Jinan Simu Decoration Space Installation and Acceptance of Jinan Milan International Decoration Switch Socket

Switch socket installation acceptance 1, foundation installation acceptance first check whether the installation position of switch and socket is correct, and the installation requirements are smooth and stable.

The box is installed completely without deformation, and the cover plate is close to the wall.

In addition, you can cut off the power supply and open the cover, and check that the wires in the box meet the requirements without damaging the wire core. The box requires good insulation treatment.

2. When installing the bottom plate of the allowable deviation switch socket in parallel, the height should be equal, and the allowable maximum height difference should not exceed 0.5 mm. ..

For all switches in the house, unless there are special requirements, the height should be equal, and the height difference should not exceed 5 mm

In addition, the verticality of the panel can be detected by messenger wire, and the allowable deviation is 0.5 mm

3, check the switch control switch is a platform for electrical equipment, its normal work can bring a lot of convenience to our home life.

When the circuit is accepted, start each switch as much as possible to ensure that the switch button is normal and the circuit connection is normal.

For some switch circuits without lamps, they should be accepted together after lamps are installed.

4. Check the power supply of the socket. At this time, an electroscope is needed. Insert the special electroscope into the socket, and then flip the switch repeatedly to check the power supply of each socket.

If the indicator light is all black, it means that there is something wrong with the power supply of this socket and it needs maintenance.

5. Socket wiring inspection In addition to checking whether the socket is electrified, it is also necessary to check whether the socket wiring is wrong.

Because some sockets may be connected with zero line, missing zero line, missing ground line, etc. Wiring errors are likely to cause circuit accidents.

The way to check whether the wiring is correct is to use the socket detector, and judge whether the socket can be electrified normally by observing the lighting of the three light areas of N, PE and L on the electroscope.

6. Protection of finished products of switch and socket Finally, whether the viewing surface is still intact at the time of acceptance, if there are mistakes in decoration, you can claim compensation.

Keep the wall clean after installing the switch socket.

In other constructions, switches and sockets shall not be damaged due to collision.