Can I not pick up the red line from the rear camera?

Pacific Auto Network does not allow it. This red line needs to be connected. It is a reversing signal line, which is usually connected to the reversing lamp. After being connected, put the reverse gear on, and the reversing light is on, so that the rear camera signal can be turned on, and the situation behind the vehicle can be clearly observed on the screen through the rear camera.

A red line of the rear camera is the reversing image control line, which can be switched to the reversing picture state under any picture condition. The most important thing to choose a car rearview camera is to look at the chip and waterproof performance. Of course, the most important thing is to see the actual effect of the image.

CCD and CMOS chips are important parts of automobile rearview camera. It can be divided into CCD and CMOS according to different components. CMOS is mainly used in products with low image quality. Its advantage is that the manufacturing cost and power consumption are lower than CCD, but the disadvantage is that CMOS cameras require higher light sources. CCD is a high-end technical component used for photography and video shooting, and also comes with a video capture card. There is a big gap between CCD and CMOS in technology and performance. Generally speaking, CCD works better, but it is also more expensive. Without considering the cost, you can choose CCD camera. (Photo/Text/Photo: Pacific Auto Network Wu Binbin)