How to attach the lens film of mobile phone?

Generally, the lens film is an electrostatic film. You can cut a piece of scotch tape, stick one end on the lens film of the mobile phone, and gently pull it up.

Mobile phone film, also known as mobile phone beauty film and mobile phone protective film, is a kind of cold film, which can be used to attach to tangible objects such as mobile phone surface and screen. There are many kinds, which can be divided into:

Mobile phone screen protective film, mobile phone body protective film.

Functionally, it can be divided into: from the initial simple scratch-resistant protective film to the introduction of functional protective film series;

Anti-peep film, mirror film, AR film, frosted film, HD film, scratch-resistant protective film, 3D film, scratch-resistant protective film for mobile phone body, diamond film, toughened film, etc.

Method for using mobile phone membrane

First, follow the steps in the photo below to clean the screen.

1. Blow off the dust around the phone first.

(2) Use the soft brush of the lens pen to remove as much dust as possible.

(3) Finally, wipe off the fine dust with a mirror cloth. Pay attention to gently wipe the mirror cloth from left to right for three times, and don't wipe it back and forth, so it is easy to move the dust left and right, and the result is still on the screen.

Secondly, the movie started.

(1) Tear off the first auxiliary film (the film for protecting the adhesive film) along the convex part. Remember, don't tear off this auxiliary film completely, just one corner, and don't expose the joint surface to the air for a long time, which is easy to get dusty.

(2) Align the uncovered side of the sub-film with the screen and slowly stick it on the screen.

(3) Use a credit card or hard plastic sheet to gently push along the pasting direction to ensure that no bubbles will be generated during pasting, and observe whether there are bubbles in the pasted part.

Once bubbles are found, they should be uncovered gently and continue to operate after dust removal. If bubbles are found after completely pasting, it will be difficult to remedy them.

(4) After complete leveling, slowly tear off the second auxiliary film on the surface. (If the screen of the model is concave, it can be glued out with transparent glue.

References:

Baidu encyclopedia-mobile phone film pasting