16 tiggo 3 can the reversing camera be replaced?

1. Open the trunk door, unscrew the screws on the trunk, and remove the partition on the trunk cover;

2. After disassembling, you can see the exposed trunk, then find the buckle of the trunk outer plate and squeeze out the white rivet on the left side;

3. Unscrew the fixing screw of the outer decorative panel of the right trunk and push the mounting hole of the left reversing camera outward;

4. There are a pair of screws on the left side of the right door lock module. Similarly, unscrew the nut and the trunk lock screw to completely separate the trunk trim panel;

5. Take out the old camera to be replaced, and then insert a new reversing camera.

6. Restore according to the wiring position of the original vehicle and connect the video cable interface of the original vehicle.

The camera can be replaced, and the signal line of the reversing image can be used by connecting new equipment. Reversing camera is an important part of reversing image. Once the camera is aging, blurred and the chip fails, it needs to be replaced, otherwise it will affect the normal display of the reversing image. The camera for reversing images is generally located at the lower end of the rear license plate rack.

It's a little troublesome to replace it yourself. Go to a professional repair shop to replace it. If it is the original car camera, it should be located in the middle of the rear of the car, between the two license plates, and the appearance of the recorder camera does not match it. Recording the time, speed and position in the video while driving is equivalent to a "black box". It can also be used for DV shooting fun at home or for home monitoring.