How to clean the camera? Camera cleaning skills

The top lens of the lens group in front of the lens is the easiest to get dirty. When shooting, my finger accidentally touched it, and all kinds of dust particles easily gathered here.

Pay attention to the coating on the lens surface. Don't wear it. First, use a brush or air blowing to remove large pieces of dust, and then use a cleaning paper or a cleaning cloth to wipe off traces such as paper lines and water stains. Artifacts such as stubborn particles and compressed air can also be used.

The last shot of the lens group behind the lens is also one of the places that are often cleaned. This needs to be cleaned by taking off the lens (SLR camera control: smmapp), because the end of the lens is concave, and it is more troublesome to clean up. When cleaning, it is best to turn the lens bayonet upside down.

2. Cleaning of sensors

The cleaning of sensors is a test of hands-on ability. Generally, blowing is the main method. Don't use cotton swabs, etc. It's easy to backfire.

Before cleaning, set the camera to "Manual Cleaning" mode, lift the reflector, and then remove the lens for cleaning. You can blow it with air first, with the fuselage facing down. When there are stubborn particles, stick them with jelly sticks.

3, the fuselage and electronic screen clean.

In addition to cleaning the lens, sensor and bayonet, we also need to clean the buttons and seams of the fuselage. Of course, the electronic screen and viewfinder also need cleaning.

There is no need to care too much about the cleanliness of these places. After all, it will not affect imaging. Just sweep away the dust and remove all kinds of scratches.

3. In addition to cleaning the camera after it is full of dust, daily maintenance is the key. Try not to go out to shoot when it is dusty or raining heavily, get into the habit of holding the lens with one hand, avoid touching the lens with your fingers, and know how to maintain and clean the camera daily. You can use it for another two years!