How to use reinforcement glue?

Drill holes according to the size required by the design drawings.

2, hole cleaning

Blow off the putty in the hole with an air pump first, then brush off the loose concrete on the surface with a brush, and then clean the hole with a high-pressure water gun. This step must be cleaned up, otherwise it will seriously affect the subsequent construction effect.

Step 3 inject glue

Install the glue injection nozzle of MT500 in a plastic bottle, insert the glue injection nozzle into the bottom of the hole, and slowly lift it out while gluing. The remaining glue can be used next time, so be careful not to be contaminated.

4, planting steel bar

After injecting glue, slowly rotate the steel bar clockwise and insert it into the bottom of the hole. The spilled glue needs to be cleaned up.

5. Maintenance

Let the anchoring glue cure naturally, and don't turn or knock the screws during the curing process.

The adhesive for planting steel bars has the characteristics of high bonding strength, like embedding, small shrinkage when curing and hardening at room temperature, good temperature resistance, weldability after embedding steel bars, good durability and weather resistance, good aging resistance, good medium (acid, alkali and water) resistance, excellent toughness and impact resistance after curing, no volatile solvent, no toxicity and environmental protection, wide distribution ratio of group A and group B adhesives and convenient construction.

Extended data:

Key points of rebar planting and screw construction: drill holes according to regulations → clean holes with brushes and cylinders → mix components A and B evenly → prepare rebar glue in proportion → inject rebar glue into holes with special tools → screw rebar or screws into holes → maintain → conduct quality inspection.

Fully stir and thoroughly clean the drilling hole, and it is forbidden to touch the rod body before curing. Protective articles such as gloves, masks and goggles must be equipped during construction. If you accidentally get it on your skin or clothes, you can wash it with acetone and then rinse it with plenty of water. If you accidentally eat or splash into your eyes, you should seek medical attention immediately.

Do not put the mixed residual colloid back into the tank. If you want to speed up or slow down the curing speed of steel bar adhesive, increase or decrease the curing agent appropriately. Please remember to put the glue in a cool place and cover the barrel with the back.

Baidu encyclopedia-planting glue