14 generation sylphy reversing image blue screen?

Pacific Auto Network 14 generation Sylphy reversing image display will automatically blue screen without video signal input, indicating that it is a signal input or camera problem. Please check whether the video head wiring is loose. If the screen is still blue after adjustment, please check whether the camera is normal. Connect the camera to another monitor to see if there is an image. It is suggested to plug in the power cord and data cable of the camera again, which may be caused by poor contact.

/kloc-The possible reasons and solutions for the blue screen of the 0/4th generation Sylphy reversing image are as follows:

1, showing the setting problem. Generally, there is a camera switch control in the settings of the monitor. The switch is set to? Open? Just;

2. If the camera fails, repair and replace the camera;

3. Line problem. The problem with the highest failure rate. Because the wiring harness of the reversing image is pulled from the dashboard to the trunk, and the wiring is long, it is likely that the wiring harness or plug in a certain place is in poor contact and needs to be carefully checked;

4, reversing camera grinding. The surface of most cameras is very fragile, so it is necessary to put a protective film on the outside of the camera.

5. The quality of the reversing camera is too poor. (Photo/Text/Photo: Pacific Auto Network Li Linwei)