Installation steps of cable camera

The rated voltage of the wire for monitoring camera should be greater than the working voltage of the line; The insulation of the conductor shall conform to the installation mode of the line and the environmental conditions for laying. The cross-sectional area of the conductor should meet the requirements of power supply and mechanical strength. When wiring, try to avoid wires with connectors.

Summary Install the chassis of the camera on the bracket, and then install the camera on the bracket. Connect the power plug and the camera plug. Connect the BNC cable to the BMC interface and tighten it with a screwdriver. After the two ends are connected, connect the camera to the computer host or camera hard disk.

Prepare camera, bracket, video cable, 12V power supply, acquisition card, etc. Determine the location where the camera is installed to avoid interference caused by mitigation; Arrange the camera circuit to connect it with the indoor computer; Turn on the power, set up the camera, and you can start using it.

Installation steps of wired cameras: For wired surveillance cameras, first determine the installation location to ensure that the surroundings will not be disturbed by the environment. After determining the location, we will carry out wiring, and there are many ways of wiring.

On-site monitoring and installation: entrance and exit control, monitoring products, comprehensive monitoring and prevention. Supermarket monitoring installation: equipped with stable transmission POE switch, 16 recorder, X-series POE camera, convenient without jamming.