Traditional Culture Encyclopedia - Photography and portraiture - How to install the rear camera of driving recorder

How to install the rear camera of driving recorder

The installation steps of the rear camera of the driving recorder are as follows:

1. After installing the driving recorder, be sure to look at the general wiring diagram in the car before the camera.

2. After determining the general wiring diagram, start the construction, install the camera near the license plate at the back of the car, and the wiring must follow the door crack, so remove the guard plate of the car.

3. Drill a hole near the license plate, and then install a camera here.

4. Pass it along the trunk and get ready to get on the bus.

5. Follow the line in the car, and the final destination is the recorder.

6. The last line reaches the recorder and is connected according to the instructions.

7. At this time, the camera behind the driving recorder was installed.