How to connect the reversing image ballast in Ming Rui?

One end of the normally open switch on the relay is connected with the power supply or battery power supply in front of the vehicle and the positive pole, and the other end is connected with the positive pole of the power line of the reversing image camera.

1. First, connect the two ends of the lamp, and connect the live wire (red wire) of the power plug to a terminal of the ballast.

2. Connect a wire at the A end of the lamp tube (we notice that the two ends of the lamp tube are the A end and the B end respectively) to the other terminal of the ballast.

3. Connect another line at the A end and one line at the B end to the two ends of the upconverter respectively.

4. Connect the other wire at the B end to the zero line (blue line) of the plug, and stick it with insulating tape.

5. At this point, the wiring is completed. When the plug is connected to the power supply and the switch light is turned on, it will light up.

Routing mode

Have a plenty of fuse box power cord. Remove the activation wire+relay from the backup lamp. The video line runs from the all-in-one machine through the driver's seat, from below the left seat to the back seat, up the left C-pillar, and through the pipe to the tailgate cover, close to the license plate light. Please repair it because there is a plug.