How to turn the camera on and off

How to turn on Sony camera, how to turn on Sony camera

1. Sony camera power-on mode: press the power above the Sony camera body, or turn on/off the power switch or turn the power switch lever to the ON position to start the camera.

Sony camera is one of Sony's high-quality products. Sony camera takes the high-end fashion avant-garde route, CCD technology is advanced, portability is high, anti-shake and automatic capture. Moreover, Sony camera also supports smiling shutter, which can capture wonderful moments. Power-on/Power-off: Press and hold the button for 2 seconds to complete the power-on and enter the standby state. At this time, the green light of the camera indicator light will be on for a long time; Press and hold this key for a long time in any state where the indicator light is on, and the camera will automatically save the current recording file and close it.

Recording video: the camera enters the camera waiting state, at which time the green light is on for a long time, press and hold the button, and the green light flashes for three times to start recording; Press the button short again to stop recording and save the file, and the red and green will change back to a long light; In order to ensure the size of the shot file ...

Where is the camera power button?

There are various positions of the on-off button of the camera, most of which are next to the shutter button, and some are in other positions.

There are many kinds of cameras, waterproof digital cameras and video cameras, and the basic principles are the same. They convert optical image signals into electrical signals for storage or transmission. When shooting an object, the light reflected by the object is collected by the camera lens and focused on the light receiving surface of the camera device, and then the light is converted into electric energy by the camera device, that is, a "video signal" is obtained. The photoelectric signal is very weak, so it needs to be amplified by pre-amplifier circuit and then processed and adjusted by various circuits. The final standard signal can be sent to video recorders and other recording media for recording, or spread through a propagation system, or sent to a monitor for display.