Traditional Culture Encyclopedia - Photography and portraiture - How to disassemble the rear camera of the new Mondeo?

How to disassemble the rear camera of the new Mondeo?

Driving recorder is an indispensable automobile product, which is often called the "black box" of the automobile. The driving recorder is generally installed on the front windshield of the vehicle (the rear of the vehicle is also equipped with dual cameras), and records the images and sounds of the vehicle during driving through high-definition lens photography. When an accident happens, it will immediately give evidence to protect the safety and rights of drivers. So how should I install the driving recorder after I bought it myself?

First of all, the current driving recorders are all installed at 5 or 6 meters, so you must run the line in the car. It's still more troublesome to install it yourself. Where the body and interior are changed, insert all the way, then run to the right, then to the central control, and then to the central control. If you don't know how to break the central control, you won't spend hundreds of dollars. So if you buy it yourself, you'd better find a master to install it and pay the working hours. If you are handy, you can install it yourself, but in order to prevent injury, you must wear gloves when operating. Before installation, please confirm whether the front/rear camera works normally.

The first step, of course, is to disassemble the corresponding parts. The main points are as follows: 1. Remove the rubber sealing strip of the front passenger door. 2. When removing the A-pillar interior trim panel, if the vehicle has a circular fixing cover as shown in the figure, please use a screwdriver or screwdriver to open the cover and unscrew the internal screws. 3. Pull and remove the A-pillar trim panel on the side of the passenger seat with both hands. 4. Remove the B-pillar trim panel with a screwdriver or screwdriver, leaving a little gap between the ceiling and the B-pillar trim panel.

Step two, connect a pair of wires at the back. 1. Connect the front and rear cables to the front lens camera. 2. Hide the butt wire into the gap between the front windshield and the ceiling by hand. 3. Hide the butt wire above the inside of the A-pillar trim panel. (If the vehicle is equipped with an airbag, fix the butt wire on the rear side of the airbag. 4. Insert the butt wire into the gap between the passenger's seat side body and the ceiling. 5. Insert the butt wire into the gap between the B-pillar interior trim panel and the ceiling. 6. Connect the docking cable to the rear camera. , tidy up the remaining wires and complete the installation. 7. After installing the rear camera above the center of the rear window glass, completely insert the rear wire into the C-pillar interior panel, between the ceiling and the rear window glass. 8. Insert the rear wire into the gap between the C-pillar trim panel and the ceiling. 9. Use insulating tape to arrange the remaining rear wires. 10. Insert the arranged rear wires into the gap between the rear body and the ceiling. Complete the installation of the remaining wires.

(Operator: He Shuguang)

Million car purchase subsidy