Illustration of mineral water bottles-how can plastic bottles be used in life after they are usually used up?

How to make a vase with a small mineral water bottle

Things that we often use up in life will be the same, in fact, many things can be recycled. For example, drinking mineral water bottles. Mineral water bottles can water flowers by sticking a few small holes in the bottle cap, so what if mineral water bottles want to be creative in making vases? Xiaobian shared several methods of waste utilization of mineral water bottles. Simple and beautiful

How to make a creative vase with a mineral water bottle

The first kind: a beautiful vase made by a mineral water bottle

When you see this vase in the above picture, you will be amazed at its beauty. Do you really want to have such a vase on your desk? But can you think of how it was made? In fact, it's just a coke bottle and mineral water bottle that are usually abandoned by us, and then it's made by a very simple transformation. Do you really want to try it? Then let's come to the steps of making diy creative vases of mineral water bottles with 63diy. I believe you can make such beautiful vases after reading them ~

You should prepare some materials first: plastic bottles and scissors.

1. first find a 5ml beverage bottle.

2. Cut it from the top of the bottle.

3. Cut it in two, leaving the lower part.

4. Then cut it vertically until it reaches the position of the pattern.

5. The width of the cut strips should be the same.

6. Cut the whole week of the bottle into thin strips.

7. Start knitting flowers now.

8. Buckle the bottle down and let all the cut strips unfold.

9. flatten the bottle so that the thin strips will not retract and rebound when the bottle is placed upright.

11. tuck article 1 in as shown in the figure.

12. tuck in article 2 in the same way.

13. Re-insert Article 3.

14. This is a panoramic view with three buttons tucked in.

15. Tuck all the thin strips in turn in the same way.

16. The closing method is the same.

17. It's finished after all the thin strips are tucked. It's very simple.

18. Show a overlooking effect.

19. You can arrange flowers.

the second type: the mineral water bottle is made into a hollowed-out vase with hot stamping

The materials required for making: beverage bottle, electric soldering iron, painting and flowers

Manufacturing steps:

1. Energize the soldering iron and heat it to make holes in the bottle body.

2. Hot holes can be done at will, and a kind of lace is made on the side of the bottle.

How to make a hollowed-out flower vase for beverage bottles

3. Connect the hot holes on the bottle body with an electric soldering iron and cut off the whole top half of the bottle mouth, so that the edge of the vase can have an irregular shape.

4. The vase body consists of irregular hot holes to form a personalized hollow pattern.

How to make a hollow vase with hot stamping for beverage bottles

5. Paint the bottle evenly with spray paint

6. Finally, fill the vase with water, insert fresh illustrations and green leaves, and finish!

the third kind: mineral water bottle, a kind of fashion vase

Material preparation: plastic bottle, dye, brush and adhesive tape.

The detailed steps of making simple vases from plastic bottles by hand at home are as follows:

Stick the adhesive tape on the plastic bottles as shown in the figure, then apply dye, and tear off the adhesive tape after the dye dries, and a simple and fashionable vase will be made.

the fourth method: making vases with hemp rope and glass bottles. How to tie the vases by hand

Making hanging vases with hemp rope and glass bottles is a simple waste using DIY. Just tie the glass bottles with hemp rope. Let's learn. .

start from the bottle mouth.

put a rope ring around the neck of the glass bottle first.

then tie the hemp rope with the rope ring.

diagram of knitting mode.

the tying rope on the bottle body is the same.

how to tie the bottom of the bottle.

after tying the bottle, you should leave a pigtail at the bottom of the bottle.

finally, tie a lanyard at the bottle mouth.

a simple and beautiful hanging vase is ready. . Tools and methods of watercolor painting

Watercolor is mainly about grasping the amount of water. Shops sell watercolor paper, not gouache paper. It's different. You can use the bottle cap of a mineral water bottle to color, and you can grasp the amount of water. Gou Xianbi can't be less. Generally, you draw the plastic bottle over and over again on the background color. How can you use it in your life after you use it?

After drinking, you don't have to throw away the bottle. You can use it to make some gadgets.

Many people especially like to go to the supermarket to buy drinks. It is more convenient to drink drinks when going out, and after drinking drinks, most people will throw away the plastic bottles directly instead of keeping them. But in fact, there are many advantages to keeping plastic bottles.

First of all, don't say anything else. It's a small sum of money just to save all the plastic bottles together and sell them to waste collectors. For some friends who save money, this method should not be missed.

Of course, we can also make plastic products into some gadgets needed in life, such as pen holders. We can cut off the top of plastic bottles first. Rub the top clean with something. The purpose of this is to prevent the plastic bottle from stabbing yourself.

then we can install some small decorations on the outside of the plastic bottle, such as sticking some stickers on the outside, which can be used to put stationery such as pencils, ballpoint pens and paper clips when finished. Is it particularly convenient?

Of course, it can be used not only as a pen container, but also as a vase. I believe many friends have also used plastic bottles as vases. It is very convenient, just cut off the top of it directly, but remember that no matter what kind of flowers are planted, it needs air. We can cut a few small holes at the bottom of the plastic bottle to help the soil vent.

When finished, you can put it directly on the balcony. If you want to make it more beautiful, you can poke a few small holes above the bottle mouth, and then string them together with ropes to make a small hanging orchid basin and hang it above the clothes rack.

It can be seen that plastic bottles can be recycled, and there are many things made.