Instructions for use of Kubi Rubik's Cube U9GT

1. switch: Press and hold the power button until the screen lights up.

Shutdown: Press and hold the power button to shut down when the machine is turned on.

2.u9gt is equipped with Android 2.3 system when it leaves the factory. The following is a brief introduction of some common settings:

① Change the address of the desktop weather display:

The default location of the factory is Wuhan. If you are not in Wuhan, you need to change the weather on the right side of your desktop weather widget, and then enter it.

In the weather program interface, click the menu button or the M key on the side to enter the program menu, and click Set Pop-up Location (Wuhan). When a dialog box pops up, click Add to pop up the dialog box, and then select the city. Finally, click Set City and select "Desktop Display".

②wifi connection

First, you have to make sure that there is a wireless network signal in your area. The specific operation method is as follows: Settings-Wireless and Network -WiFi Settings, then click the network you want to connect to, and then click Connect.

③ screen setting

Open Settings-Display, which is the relevant setting of the screen; ; Brightness is the brightness of the screen. Auto-rotating the screen means that when you turn the machine, the screen will rotate with you. This can be set according to personal needs. Screen timeout means that when you don't move the device for a period of time, the device automatically turns off the backlight and enters the power-saving standby mode.

④ ④ Introduction of ④④otg interface function

Otg interface is located on the left side of the machine, which has the same appearance as miniUSB interface, but its function is different from USB interface.

Function 1: Connect U disk, you can connect u9gt through otg interface, and then open the resource manager that comes with the system to browse the contents of U disk;

Function 2: Connect the wired network and the network cable. You need a router at your location. Because there is no dial-up software suitable for tablet computers at present, it is temporarily impossible to dial-up the Internet directly through ADSL.

⑤ Connect the computer through USB.

First, listen to the data cable and USB interface on the tablet to connect to the computer, then drop down the notification bar, click USB connection to pop up the interface of USB data connection mode, and click the "Open USB storage device" button to connect, then you can see that there are two mobile disks in your computer, one is the body memory, and the other is the memory of the memory card through the memory card slot.