What's wrong with Steyr's rear eight-wheel fault light?

Low engine oil pressure oil pressure warning light: This light is connected to the central STOP warning light STOP. When the engine is running, if the indicator light is on and accompanied by a buzzer, and the multi-function display shows "Low oil pressure", please stop immediately. When the lubrication system is short of oil, please add it to a reasonable oil level.

1. Poor gasoline quality will lead to insufficient combustion of the mixture in the cylinder, which will lead to lamp pollution and carbon deposition.

2. The existence of carbon deposits at the air inlet and piston top will lead to poor atomization, resulting in insufficient combustion and pollution of lights.

3. When the cold car starts, especially when the weather temperature drops sharply, the pollution lamp will light up due to the temperature correction problem of the computer, but as long as the temperature drops to a certain temperature, it will be relatively stable without fluctuation.

4. If the mileage of the engine is too long, the working characteristics of the spark plug will be weakened, leading to the lighting of the pollution lamp.

5. Too much carbon deposit and difficult ignition will lead to reverse breakdown of the ignition coil, failure of the ignition coil, poor ignition and incomplete combustion, which will cause light pollution.

6. Inappropriate ignition timing and premature ignition lead to premature combustion and detonation of combustible mixture; Due to the ignition system failure, the spark plug is broken or the spark plug is not firm;

7. Cylinder compression pressure: the piston, piston ring and cylinder are seriously worn, which increases the fit clearance between the piston, piston ring and cylinder, and the sealing performance becomes worse, resulting in air leakage in the cylinder head and reducing the compression pressure of the cylinder; Due to poor sealing, the crankcase leaks air and the suction is reduced;

8. Check whether the air filter is blocked and remove it if necessary;

9. Check the throttle opening. When the accelerator pedal is pressed to the bottom, the accelerator should be fully opened; Otherwise, adjust the cable or study the pedal position sensor and throttle position sensor.