There is an urgent need for instructions on the use of intelligent solar controller with Linoret, Sunshine Treasure 3.

1. Insert the sensor from the overflow pipe, gently pull the lead wire to make it close to the entrance, then extend inward about 1 cm, and then put the fixing piece on the overflow pipe.

2. Introduce the sensor special line into the room and fix it. Don't use too much force to avoid being scratched or broken.

3. During installation, it is forbidden to damp the socket. The sensor should not collide with or get too close to the electric heating tube.

4. If the lower sensor is selected, install it upward from the bottom of the water tank, and tighten the fixing nut to check whether there is water seepage.

5. If the sensor is installed now, install it downward from the top of the water tank and fix the wire with a tie.

Extended data:

1. To use household solar energy, it is necessary to open the cold water valve first, adjust it to a suitable cold water temperature, let the cold water flow out slowly, then open the hot water valve to release running water and mix it with cold water to form warm water. Pay attention to open the hot water valve less every time to prevent burns.

2. The water supply of domestic solar water heater depends on the weather. Fill the water tank full on sunny days, half on cloudy days, and no water on rainy days.

3. The channel power of electric heating is1500 W W. If it is used on cloudy days or when the water temperature is insufficient in winter, don't plug it in for a long time. You must cut off the power supply when taking a bath. When plugging in, if the red light of the leakage protection plug is on, it proves that it is heating, and the green light indicates that the water temperature has reached 65℃.