What is the difference between three-layer solid wood composite flooring and multi-layer solid wood composite flooring?

1. Multi-layer solid wood composite flooring and three-layer solid wood composite flooring are both solid wood composite floors. They are made of solid wood veneers or panels of different types, using environmentally friendly glue and pressed under high temperature. , among which, three-layer solid wood composite flooring is made of three layers of solid wood veneers staggered and laminated.

2. The surface thickness of solid wood composite flooring is very good, which can reach about 2mm. It is relatively wear-resistant. Pine and fir are commonly used in the middle and bottom layers for balance and stability, and the cost is relatively high;

3. The surface layer of multi-layer solid wood composite flooring is very thin, only about 0.6-1mm. The bottom layer is made of miscellaneous wood. The quality mainly depends on the glue used.

To maintain the three-layer solid wood composite floor, the specific measures are as follows:

⑴The humidity in the room should not be too high, keep the floor dry, smooth, and clean it daily with a well-wrung cotton mop. That's it; if you encounter stubborn stains, you should wipe them with a neutral cleaning solvent and then wipe them with a wrung-out cotton mop. Do not scrub with organic solvents such as acids, alkaline solvents, or gasoline.

⑵ During daily use, pay attention to avoid scratching the floor with heavy metal sharp objects, glass tiles, shoe nails and other hard objects; do not let the floor come into contact with open flames or place high-power electric heaters directly on the floor; it is prohibited to Place strongly acidic and alkaline substances on the floor; prolonged water immersion is absolutely prohibited.

⑶ In order to maintain the beauty of the three-layer solid wood composite floor and extend the service life of the paint surface, it is recommended to wax and maintain it twice a year. Wipe the floor clean before waxing, then apply a layer of floor wax evenly on the surface. After it dries slightly, wipe it with a soft cloth until it is smooth and shiny.

⑷ If a large area of ??water is accidentally flooded or a local area is soaked in water for a long time, if there is any open water, it should be wiped dry with a dry cloth in time and allowed to dry naturally. It is strictly prohibited to use electric heaters to dry or dry in the water. Exposed to the sun.

⑸ Long-term exposure to strong sunlight or sharp rises and falls in room temperature may cause premature aging of the solid wood composite floor paint surface, and should be avoided as much as possible.

⑹ If the installed place will not be occupied temporarily, the indoor air circulation must be maintained. Do not cover it with plastic paper or newspaper to avoid the surface paint film becoming sticky and losing its luster over time.

⑺Clean and vacuum the floor regularly to prevent sand or frictional dust from accumulating and scratching the floor surface. Place a doormat outside your door to prevent sand or abrasive dust from being brought indoors. When cleaning the floor, you can use a well-wrung cotton mop to wipe it.

Do not use wet mops or corrosive liquids (such as soapy water, gasoline) to wipe the floor.

⑻ If the outdoor humidity is greater than the indoor humidity, you can close the doors and windows tightly to keep the indoor humidity low. If the outdoor humidity is lower than the indoor humidity, you can open the doors and windows to reduce the indoor humidity. In humid and hot weather, you can turn on the air conditioner or electric fan.

⑼In order to increase indoor air humidity in autumn and winter, a humidifier can be used to keep the indoor air humidity at 40%-80%.

⑽ When moving furniture, you should not push or pull it directly on the floor. You should lift it, move it and place it gently. Frequently moved furniture can have a layer of rubber glued to the bottom.

Reference: Three-layer solid wood composite floor-Baidu Encyclopedia