Difference between soaking brick and non-soaking brick

The difference between water-soaked bricks and non-water-soaked bricks is 1. Water-soaked bricks need to be soaked before they can be pasted with cement. If the water-soaked brick does not soak in water, using cement directly may lead to cracking or cracking of the tile in the later pasting process. If the brick is not soaked in water, cement mortar can be used directly without soaking in water.

2. Cement and brick can be better bonded during construction. After good use, there will be basically no cracks and hollows in the later period, and the firmness of non-instant brick is not as good as that of instant brick. Even if you buy bricks that don't soak in water, it is better to soak them a little before use.

What are the precautions for brick wall construction? 1. When we build a wall with bricks, we must use brick mortar, which must be used up within three hours. If the weather is hot, the mortar must be used up within two hours, otherwise the adhesion between mortar and brick will be affected.

2. When laying bricks again, be sure to ensure the flatness of bricks, which can be measured by measuring instruments.

3. When building walls, the daily wall height should not exceed 1 m 8 or so. If it exceeds 1 m 8, it is likely to cause some stability problems of the wall.

Why do tiles have to be soaked in water? 1. Tiles are soaked in water, which can prevent them from absorbing water in cement slurry, resulting in hollowing, falling off or cracking of tiles. Generally, when the wall is paved, water should be sprinkled on the wall first. The tile itself has cracks. Soak water first to make its pores fully absorb water, so that its water absorption rate reaches the minimum standard when paving.

2. If the water is not soaked properly before paving, its embryo will not absorb enough water. After the tile is laid, it will absorb the moisture of mortar, which will affect its function and lead to empty drum. Empty tiles can't bear great external force, and once they are hit, they are easy to crack. The empty drum area becomes larger and it is easy to fall off or fall off, so it is very important for tiles to soak in water, but this does not mean that all tiles must soak in water.

3. When steaming and soaking water, all tiles must be immersed in water, so when soaking tiles, the area of the basin must be large enough and the amount of water must be sufficient. The water depth should not be lower than the height of the imbricate in the basin. If the basin is too small or the water depth is not enough, there is no guarantee that the tiles will be completely submerged and then fully absorbed.