Traditional Culture Encyclopedia - Weather inquiry - B2 weather push

B2 weather push

The biggest difference between subjects b2 and c 1 is that the test items are changed from 5 to 16, except for the control of the car and the driving skills that need to be mastered. The whole process of b2 subject 2 examination is as follows.

Preparation before exam

1. Enter the waiting area with your admission ticket and ID card. The display in the waiting area will show the arrangement of each candidate. At this time, we will wait for the staff to call their names.

2. After reading the name, the staff will give the admission ticket and ID card to the staff in the examination room and take the test bus on the designated road according to their instructions.

3. After getting on the bus, adjust the seat and rearview mirror to a proper position, and then fasten the seat belt; Then complete the identity authentication according to the voice prompt of "authentication", and then prepare for the exam according to the voice prompt.

1, stop and start the ramp at a fixed point.

Fixed-point parking and starting on the ramp mainly examine whether the candidates can control the vehicle on the ramp, whether they can stop accurately, prevent slipping back and start smoothly. When you hear the voice prompt of "Stop and Start at a Fixed Point on the Ramp", drive the car halfway up the ramp and stop at the designated place. After parking, the right wheel distance is not more than 30cm from the road edge line, and the front of the car is within the foremost yellow line.

2. Lateral parking

When the vehicle stops at the front right side of the garage and hears the voice prompt of "start parking horizontally", it should be poured into the garage at one time. When reversing, you must not stop halfway, and the wheels must not touch the road sideline and the garage sideline.

3. Through unilateral bridge

After the sound of "Start Passing unilateral bridge" sounds, put the car into second gear or above, and then drive forward to let the left front and rear wheels pass on the unilateral bridge. As long as they don't stop halfway, the wheels don't fall off the bridge, and so does the right wheel.

4, curve driving

After the sound of "start driving in the corner" sounds, drive in from one end of the corner and keep it steady during driving. During driving and turning, don't stop halfway or hit the edge line of the road, just drive out smoothly from the other end.

Step 5 turn at right angles

After the sound of "start right-angle turn" sounds, drive the vehicle according to the specified route, and then make a right-angle turn to the left or right. In this process, you must pass at one time, and you must not stop or touch the roadside.

6, through the width limit door

After the sound of "Start to pass through the width-limiting door" sounds, pass through the three width-limiting doors at the speed of 10km/h, and don't touch the boom.

7. Pile test

Stop in the garage at the starting point of pile testing in advance. After hearing the voice prompt of "start pile inspection", pour into garage B from the starting point to stop, then move in and out to garage A to stop, then move forward from garage B to the control line, pour into garage A to stop, and move forward back to the starting point. Vehicles shall not stop on the way forward and backward, and the running time shall not exceed 8 minutes.

8. Turn around on the narrow road

Drive the car to the U-turn and stop. After hearing the voice prompt of "turn around in the narrow road", turn around in a way of no more than three in and two out within 5 minutes.

9. Simulate the highway

After the sound of "start to simulate the highway" sounds, drive the car to the on-ramp and turn on the left turn signal. Look back and watch the coming car to the left. After confirming the safety, accelerate into the driveway, drive normally after the minimum speed limit, and turn off the turn signal. When it is necessary to change the lane, you should turn on the turn signal on one side of the lane, observe the incoming traffic flow, and change the lane after confirming the safety. When driving out of the expressway, you can adjust the speed and lane in advance according to the exit warning signs.

10, simulating emergency treatment

After the voice of "Start simulating emergency treatment" rings, the voice system will randomly extract the emergency when driving. If there is an obstacle ahead, brake quickly and turn on the danger flash when it stops. If it is a vehicle failure such as a flat tire, it is necessary to slow down reasonably and stop slowly according to the road conditions behind. After turning on the hazard warning flash, put up warning signs, evacuate the outside of the guardrail and simulate the alarm.

1 1. Simulate continuous steep mountain driving.

After the sound of "start to simulate continuous steep mountain road" sounds, slow down before driving to the corner, then drive to the right, honk the horn and drive into the corner, and don't occupy the other lane in the process.

12, simulated tunnel

After hearing the voice prompt of "start simulating tunnel", drive to the front of the tunnel and follow the signs. When you get to the tunnel, slow down, turn on the headlights and honk, when you get to the exit, honk and turn off the headlights. But it should be noted that don't honk in the area where honking is not allowed.

13, simulating wet pavement.

After the sound of "Start simulating wet road surface" sounds, slow down in front of the wet road section, and then pass through the wet road surface at a uniform speed.

14, simulating rain and fog weather

After the sound of "start to simulate rain and fog weather" sounds, according to the rainfall, slow down and open the gear corresponding to the wiper. Turn on fog lights, headlights, danger warning lights, etc. In foggy days.

After passing all the projects, we will wait for the voice broadcast prompt. This is the whole process of b2 subject 2.

B2 Subject 2 Examination Equipment Requirements

In general, b2 subjects basically switch between first gear and reverse gear. Generally, one grade can be used in the exam, but individual events will require two grades or more, such as unilateral bridge crossing and continuous obstacles.