Does the car film have anything to do with the weather?

The car film has something to do with the weather.

Car film usually needs a special dust-free workshop, and there will be professional spraying, humidification, air conditioning, dust removal and other equipment. In this stable temperature and humidity environment, the possibility of defects in film pasting operation is greatly reduced. If there is no dust-free workshop, try to choose cloudy days or after rain. The reasons are as follows: after the rain, the air is humid, there is less dust floating in the air, and the environment is closer to the dust-free film workshop. Movies are afraid of dust. Once there is sand or fine dust stuck between the film and the glass, the quality and effect of the whole film will be affected.

In addition, many automobile glasses now have the function of heating and defogging, and it is not recommended to use this function within one month after filming in winter. The change of temperature during heating and defogging will cause bubbles in the film, which will affect the vision of drivers and passengers in the car.

Matters needing attention after car film pasting

1. Avoid lifting the window within three days after pasting the car film;

2. Don't wash the car within three days;

3. Vehicles with skylights are driving within three days, especially at high speed. Don't open the skylight;

4. After shooting in winter, it is recommended not to lift the window and wash the car for a week. It takes about a month for the front and rear gears to completely dry. The front bumper should be exposed to the sun during the day. Most notably, the heater of the rear bumper can't be turned on for one month, because if the heater is turned on after film mulching in winter, bubbles will be generated near the heater, which can't be repaired, which will cause unnecessary losses and troubles.

5. If the edge of the membrane bubbles, it should be repaired at the construction site within 24 hours. If it exceeds the time, it will be dealt with. Because the glue around the bubble has dried up, the periphery of the membrane can no longer move, and creases will definitely appear during treatment.

6. It is forbidden to stick the super adhesive label directly on the film within one month after sticking the film, so as not to cause the separation between the film and the glass.