Traditional Culture Encyclopedia - Weather inquiry - Hot weather factory

Hot weather factory

First of all, please install 80mm or 120mm chassis fans on the I/O version corresponding to the cpu position at the back of the chassis, and on the front panel and graphics card position of the chassis side panel (according to the specific situation of the chassis). The direction is to exhaust the hot air in the chassis to the outside, and only the front fan blows the air into the chassis. As long as this kind of fan is cheap and quiet, it is recommended that overclocking three whirlwind 80MM ultra-quiet chassis fan has 3 fans as long as 45 yuan. Cooling depends on your power supply location.

1. power supply. For amd platform, it is impossible to use tower side blowing to dissipate heat, because the wind can only blow to the power supply or graphics card/North Bridge. Therefore, with the traditional push-down fan, you can use DEEPCOOL Beta β400 Plus of 109 yuan, 800-2800 rpm, 92mm fan, and the limit wind speed is a bit noisy. If the motherboard can be temperature-controlled, the medium-high speed should be quieter. Or go to DEEPCOOL) ice wing 5 multi-platform CPU radiator 183 yuan, the limit speed is 1800, which is much quieter, and the heat dissipation of 12cm fan is much better.

2. The power has been turned off. It is recommended to blow away the heat with the tower side and blow it toward the top of the chassis. I want to know if your coat is open, if not, it doesn't matter. Isn't it a rear exhaust fan? 139 yuan buys overclocking three Red Sea-Extreme Edition All-copper design has good heat dissipation, but it is a bit large, with a height of 12cm, and the wide-side cover of the mini chassis cannot be closed.

To sum up, the overall cooling plan 160-230 yuan.

Three chassis fans and a cpu with 150 yuan are much better than a single CPU 200 yuan, I can guarantee it.

As a supplement to the problem, I have seen that overclocking 3 Red Sea can be installed in four directions, that is to say, air can be blown to the back of the chassis, so lz is recommended to use this to dissipate heat regardless of whether it is equipped with power supply or not.