How to solve the screen flower caused by computer humidity?

Solution to screen blooming caused by computer humidity: \ x0d \ x0d \ 1. Before the computer is turned on, use a hair dryer to blow air back and forth from the cooling hole behind the monitor to dry the moisture inside the monitor. \x0d\ 2。 Put the computer in a well-ventilated place and turn it on for a while. The longer the boot time, the heat inside the computer will make the small water droplets attached to it evaporate. \x0d\ 3。 Do not turn off the monitor when turning it off, so that it is in standby state. \x0d\ \x0d\ How to protect the computer from moisture? Tips for protecting computer from moisture: \ x0d \ x0d \ 1. Use it for several hours every day, and use the heat generated by work to protect the computer from moisture. The best way is to turn on the computer often, preferably for one hour every day, and use the high temperature generated by computer operation to disperse the water vapor and keep it dry. For those computers that are not often used, it is recommended that you open the case, stick several bags of desiccant in the food bag on the inner wall with double-sided tape, and then cover the dust cover in time, which can basically avoid the interference of water vapor. \x0d\ 2。 Try to avoid the chassis touching the ground and walls. Many users like to put the chassis directly on the ground and pad it with foam or something. In fact, it is the easiest way to get the chassis wet. If your chassis is placed on the ground or near the ground and walls, remember to put it on the desktop when wet weather comes, preferably in a well-ventilated place, so as not to make the computer damp \x0d\ 3. If you don't use the computer often, you can open the computer case and put desiccant around it. Stick a few packets of desiccant on the inner wall of the chassis. Put a big dehumidification box outside the monitor. Cover it with a dust cover when not in use. \x0d\ 4。 If it is found that the humidity is very high, you can start the dehumidifier indoors, and blow the back of the cabinet or the monitor with a hair dryer for a while before turning it on. \x0d\ 5。 In wet weather, these exposed interfaces may not work properly due to humidity. So, if you don't use the socket, you can use a dry buffon to hold the socket. Note that it is best to use the socket once in a while. \x0d\ 6。 If the monitor is blurred when it is turned on, it will be clear in about 5- 15 minutes. If it is turned off and turned on again after cooling, the failure phenomenon reappears, then the CRT base is oxidized by moisture; Just replace the picture tube bracket. \x0d\ 7。 Make sure that the computer is properly grounded, because it is not properly grounded, which is particularly easy to cause the fuselage to be charged. Don't underestimate this little static electricity, it is also likely to destroy the computer. \x0d\ 8。 Use activated carbon, moisture-proof bags or moisture-absorbing boxes. We can open the side panel of the chassis and stick the activated carbon or adsorption bag inside the chassis with adhesive tape, which can effectively prevent the interior of the chassis from getting wet and play a very good role. Because it is inconvenient to put the moisture-absorbing box in the chassis, but it looks beautiful, we can put the moisture-absorbing box next to the monitor, which can protect our computer in all directions and use it with confidence. \x0d\\x0d\