Linen will turn yellow after washing.

Clothing bleaching and soaking paste masterbatch

Bleaching and Soaking Technology of New Generation Reactive Oxygen Clothing

1, powder formula: 5- 10% color master batch garment foam cream +90-95% basic powder (sodium silicate, soda ash and baking soda are all acceptable) = garment foam powder.

2. Formulation of aqua: 5- 10% master batch of clothes foam cream +2% super universal activator +88-93% water+preservative+essence+wire drawing powder = clothes foam solution.

3. Paste formula: 5- 10% color masterbatch garment foam cream +6% four-in-one thickener +84-89% water+salt+preservative+essence+wire drawing powder = garment foam cream.

4. Self-use: Bleaching and soaking cream masterbatch for clothes mixed with about 1% water.

Clothing bleaching and soaking paste masterbatch is a new generation of active oxygen clothing bleaching and soaking technology active agent masterbatch newly developed by Chengdu Hengfeng Hongye detergent factory. It has the following characteristics:

First, a new generation of reactive oxygen species bleaching and soaking technology.

1, bleaching various industrial oils, mineral oil, inorganic oil, petroleum, petroleum accessory products, lubricating oil, mechanical oil, mineral oil, clutch oil, gear oil, engine oil, ink, demoulding oil, compressor oil, refrigeration oil, vacuum pump oil, internal combustion engine oil, diesel engine oil, gasoline engine oil, marine oil, bearing oil, guide rail oil and hydraulic transmission oil. Clothes contaminated with oils such as methyl hydrogen silicone oil, methyl phenyl silicone oil, methyl chlorophenyl silicone oil, methyl ethoxy silicone oil, methyl trifluoropropyl silicone oil, methyl vinyl silicone oil, methyl hydroxyl silicone oil, ethyl hydrogen silicone oil, hydroxyl hydrogen silicone oil, cyano silicone oil, damping silicone oil, diffusion pump silicone oil, hydraulic oil, insulating oil, heat conduction oil and brake oil. Self-use ratio: 1%, soaking time 1-30 minutes.

2, bleaching all kinds of old dirt, old sludge, old stains, old stains, industrial stains, civil stains, life stains, sweat stains, fine spots, heavy oil stains, environmental stains and other contaminated clothing. Self-use ratio: 1%, soaking time 1-24 hours.

3. Bleach all kinds of clothes contaminated by ballpoint pens, markers, oil paints, oily handwriting, colored pens and gel pens. Self-use ratio: 1%, soaking time 1-24 hours.

4. Bleach all kinds of polluted clothes such as gray, yellow and black. Self-use ratio: 1%, soaking time 1-24 hours.

5, it can be recycled repeatedly, which saves cost and has low alkalinity and foam.

Second, the purpose of self-use:

About 65,438+0% of the clothes are dissolved in water with the master batch of bleaching soaking cream. After about one hour, the articles are soaked in the solvent, and the soaking time depends on the articles.

3. The formula of clothes bleaching and soaking agent:

1, powder formula: 5- 10% color master batch clothes bleaching cream +90-95% basic powder (sodium silicate, soda ash and baking soda are all acceptable).

2. Formulation of aqua: 5- 10% master batch of clothes foam cream +2% super universal activator +88-93% water+preservative+essence+wire drawing powder = clothes foam solution.

3. Paste formula: 5- 10% color masterbatch garment foam cream +6% four-in-one thickener +84-89% water+salt+preservative+essence+wire drawing powder = garment foam cream.

Four, production formula and production process:

1) Production of liquid products:

1, formula: 5- 10% color master batch clothes bleaching cream +2% super all-purpose activator +88-93% water+preservative+essence+wire drawing powder.

1), 5- 10% color masterbatch.

2) Super universal activator 2%

3) Appropriate amount of essence, pigment and preservative.

4) wire drawing powder 100 Jin of water plus 50g.

5), water 85-99%

2. Production technology: add the foam cream masterbatch, super universal activator, essence, pigment, preservative and wire drawing powder into water, stir and dissolve, and defoam.

2) Production of paste products:

1, formula: 5- 10% color master batch clothing foam cream +6% four-in-one thickener +84-89% water+salt+preservative+essence+wire drawing powder.

1), 5- 10% color masterbatch.

2), 4-in-1 thickener 6%

3) Appropriate amount of essence, pigment, preservative and salt.

4) 4-6% 4-in-1 thickener, quantified according to the required consistency. The higher the concentration, the greater the dose.

5) wire drawing powder 100 Jin of water plus 50g.

6), water 84-89%

2. Production technology: add the foam cream masterbatch, four-in-one thickener, essence, pigment, preservative and wire drawing powder into water, stir and dissolve, and then see if the consistency meets the requirements. You can try to adjust the consistency with salt and finally defoam.

3. How to adjust the proportion of salt?

1), initial salt ratio: First do a small test of one kilogram of product, the method is: pinch a little salt with your fingers (don't use a spoon), put a little less, put it once and stir it to dissolve, then put it again. When the consistency is generated, putting salt three times in a row can't improve the consistency, which shows that the salt ratio is enough. Salt should be measured first, and the proportion of salt used in one kilogram of products should be determined, and then the proportion needed for production should be enlarged.

2) Determine the proportion of salt: If the proportion of salt used in one kilogram of product is enlarged to the proportion required for production, there will be certain measurement error and it needs to be readjusted. Adjustment method: Knock out one kilogram of the prepared washing liquid and adjust the proportion of salt to the thickest state, then you can know the final proportion of salt.

3) Adjusting the proportion of salt: changing the variety of salt (edible salt, industrial salt, brine and raw salt), changing the weight of water, adjusting the formula, adjusting the cost and adjusting the raw materials involves one of these situations. Note: too much salt will turn into water, and the aqueous solution will turn white.

4) Beginners do experiments. First, do a small experiment of one kilogram of products. After all the raw materials are dissolved, divide them into ten parts to adjust the salt, and find a way first.

3) Production of powder products:

1, formula: 5- 10% color master batch garment bleaching cream +90-95% basic powder (sodium silicate, soda ash and baking soda are all acceptable).

1), 5- 10% color masterbatch.

2) 85-98% of basic powder

2. Production technology: Add the master batch of the clothes bleaching and soaking paste into the basic powder (soda ash, sodium silicate and baking soda) and stir evenly.

Five, preservative application guide:

1, factors affecting shelf life: preservatives play a role in quality assurance, that is, keep the product from deteriorating. There are many reasons for deterioration, such as the cleanliness of water, bacterial infection of processing equipment, accelerated bacterial reproduction in hot weather, residual bacteria on packaging and so on.

2. Dosage of preservatives: There are many kinds of preservatives, depending on the content and quality effect, and how much can be sent to achieve the quality guarantee effect. If you put more, the cost will increase, and if you put less, the shelf life will be short. The amount of preservatives should be determined according to the requirements of their shelf life. Taking Song Kai preservative stock solution (10% content) as an example, the reference ratio in two months is: 20g in summer 100kg of water, 20g in spring and autumn10g in winter. If the demand is guaranteed for a long time, it is necessary to combine various factors to set the proportion, and there is no unified standard.

3. It is suggested to install purple light in the production workshop for sterilization.

4. When producing alkaline products, preservatives should be added to water first, and then other raw materials should be added.