How to make a small acrylic display stand? Its manufacturing process is divided into several steps.

Small acrylic display stands are rare in our daily life, but in some special occasions, such as conference halls and other places, the display stands are very important at this time. Next, I mainly introduce how to make a small acrylic display stand and its manufacturing process steps.

I. Design drawings

It is the first step to design drawings with appropriate size according to user's requirements. Note that the dimensions on the drawings must be accurate, otherwise it will affect the later production.

2. Blanking and cutting of acrylic board

According to the specifications on the drawing, cut the whole acrylic board into the required size first. Usually, the cutting material should be 0.5-3 mm larger than the actual size. Pay attention to the correct size when blanking to avoid wasting plates after making mistakes.

Third, trim the incision

Repair and smooth acrylic incision. At present, most trimming work is done by trimming machine, which can save a lot of manpower and improve efficiency on the one hand; On the other hand, the trimming machine has high machining accuracy and stable rotating speed, so the trimming effect is much better.

Fourthly, surface grinding and polishing.

So as to restore the brightness of the damaged acrylic part. Common polishing methods include cloth wheel polishing, flame polishing and diamond polishing. When using the cloth wheel polishing machine, you can coat some polishing soap on the cloth wheel to speed up the polishing speed; If there are scratches on the surface of the plate, it should also be polished.

Fifth, hot bending forming.

In order to make some beautiful shapes, acrylic booths often need to be bent in some places, and some have radians; Some just bend directly at a certain angle. Both cases need to be made on a hot bending machine.

It should be noted that the hot bending parts must be accurately identified, strictly according to the dimensions on the drawings, and ensure that the heating parts are evenly heated during the heating process, so that the folded appearance can be beautiful and accurate.

6. Post-bonding and assembly

Bonding and splicing acrylic plates to form the required finished products. The common binder is chloroform solution. Usually, the injection needle tube is used to pump the solution into the gap to be bonded, which can avoid a large amount of solution overflowing and affect the appearance of the product; Crystal glue is usually used for large area bonding. This glue is transparent and firm.

Finally, if it is made for customers, it must be sealed when it is packaged and sent out to avoid friction, so as not to affect the later receipt.