Portable poster frame assembly drawing-how to install wedding poster frame, wedding welcome poster picture

The installation method of the newspaper rack is very simple. I installed one the other day, but I didn't know how to do it at first. But after reading the whole picture of the newspaper rack, you only need to erect the two main racks as shown in the figure, and then screw the two ends of the two support rods (usually one up and one down) with the two main racks respectively. Then, you just need to put the number of newspaper clips on it. Finally, there is a magazine box, just like two support rods, just tighten the two sides. You may need someone to help you when tightening.

Note: Both ends of the two support rods may have been tightened before installation. At this time, you should take out the screws with a screwdriver, and then pass through the main frame to fix the support rod and the main frame.

Of course, different newspaper racks are installed in different ways. I wonder what kind of newspaper rack you have, brother. I installed a traditional newspaper rack. After loading, put the newspaper on the newspaper rack and look at the fruits of your labor, which is both gratifying and fulfilling.

I believe many people are very happy when taking wedding photos, and the shooting process is not complicated. Most people will still go to the photo studio to take photos, but in fact, if they have equipment, they can also take photos directly at home. After the wedding photos are taken, some people still don't quite understand how to combine the wedding brackets. For details, please refer to how to install wedding photo poster bracket and wedding photo welcome poster picture.

The assembly method of gauze poster bracket is as follows: firstly, rotate the bottom of the poster bracket 90 degrees and put it down, then directly tear off the sticky paper on the drawing axis guide rail of the poster bracket, align and level the finished pictures, then open the plastic cover at one end of the painting rod, pull out the plastic core rod inside and put it back on the metal tube cover, finally press the bottom, pull the picture bar by hand, pull out the plug outside the end of the display bracket, and collect the pictures into the progress bracket.

In fact, many couples don't know much about marriage. When they are considering putting welcome photos, most of them choose to use playful photos as welcome photos, which makes the scene full of active seven points and also wants guests to feel happy. However, it should be noted that when choosing, you can choose a slightly good-looking photo, don't spoof wedding photos, and don't use black and white tones.

When placing the welcome photo, you can put it directly in the entrance lobby of the hotel, so that guests can see it at a glance. The photos are mainly festive, then marked with the names of the bride and groom, and then the posters are filled with greetings, or simply write a love story of two people or something memorable. Finally, after the wedding, you don't have to throw away the welcome photo, you can save it as a souvenir, which is also a good memory.

How to make a flea market poster bracket 1? First, take out the flea market poster that needs to be installed.

2. Then fix the bracket base and insert the other two poles into the holes at the four corners.

3. Finally, from top to bottom, fix the four corners of the poster on the small hook of each leg of the bracket in turn, adjust it to a suitable position as needed, and finally straighten it.