How to drain the jacuzzi?

When using a jacuzzi, you need to pay attention to various matters, such as how to drain the water. How do you fill the jacuzzi with water? PChouse will take you to learn more about it.

1. The most common drains for discharging water in massage bathtubs include reversing type, pop-up type, and drawstring type. If it is a reversing type, you can release the water by lifting it up; if it is a pop-up type, you can release the water by pressing it up. As for the pull-string type, of course, you only need to pull it to release the water. The massage bathtub should have a water outlet. During installation, a pipe will be connected to the sewer, which is very convenient for draining water.

2. When draining the massage bathtub, first put the sewer pipe in place, connect the hot and cold water in the bathtub, plug in the power supply of the bathtub (note: there must be a good grounding wire), and put the bathtub in place. Move it to the appropriate position, and then use glass glue to fix the tub and the wall. It can be used after 24 hours.

3. If the massage bathtub is drained manually, it will be very troublesome. You have to pull a wire inside the bathtub to open the drain valve. The simplest way is to immerse a hose in the bathtub to fill it with water, then place one end at the bottom of the bathtub and the other end in the floor drain to suck out the water inside.

4. Now there is a fully automatic control massage bathtub. The bath water temperature and volume can be pre-set. The entire process of water inlet, heating, buzzer reminder, heat preservation, residual water discharge and ozone disinfection is controlled by the computer. It is completed automatically and the operation is very simple. If conditions permit, you can buy this kind of bathtub and drain the water with one click.