Traditional Culture Encyclopedia - Hotel accommodation - Install the bathroom shower glass partition

Install the bathroom shower glass partition

When we decorate the bathroom, it is necessary to install a shower glass partition in the bathroom, but unfortunately we don't know much about it and don't know how to install it. Next, I will introduce the installation steps of the bathroom shower glass partition and the precautions for installing the bathroom shower glass partition at night.

Firstly, the installation steps of shower glass partition in bathroom are introduced.

1, according to the requirements of plane layout, draw lines on the wall and the ground, determine the installation position of the side rail and the ground rail, and ensure the horizontal and vertical (top beam and ground rail) and vertical (side rail); Move the side rail to the boundary line, drill the wall directly through the hole in the groove, and knock the expansion rubber plug into the hole (as shown in figure1); (Further reading: How to deal with the glass partition when the wall is not vertical, and how to connect the glass partition with the ordinary wall)

2. Reset the side rail and lock the side rail on the wall with 5x40mm tapping screws. Then fasten the side sealing edge (first connected with the center pillar) on the side rail, and then reset the grounding rail without connecting with the ground. Then slide side column corner codes at both ends of the top beam and the ground rail; Move the side cover (first connected with the center pillar) into position, and the lower end of the side cover is close to the end face of the ground rail.

3. Connect the top beam and the ground rail with the side sealing edge and the side cover through the corner code of the side column, then obliquely put the center column into the groove of the top beam and the ground rail, and then slowly pat the center column. Put the large glass cover into the ground rail groove, with the left and right notches attached to the central column, and the large glass column attached to the central column; Put the module into the ground rail groove, put the beam and the big glass cover, and fix the horizontal and vertical short battens; After installing the top module, lower the top edge and secure the top cover. Then remove the short vertical batten, knock the long vertical batten into the central column, remove the short horizontal batten, and knock the long horizontal batten into the cross beam.

Second, the bathroom shower glass partition installation matters needing attention

1, the glass door should be made of organic or tempered glass. The glass door of the shower room should be made of organic or tempered glass to avoid injury. If the glass is colorless, it is best to stick a pattern in a place far away from the line of sight to avoid damaging the glass.

2. Consider whether the glass partition of the bathroom has a door frame to block water. If not, it is necessary to install a special threshold stone. Generally, the threshold stone should be 1.5 cm-2 cm higher than the ground. Otherwise, the shower water will flow out from the door, which will not achieve the purpose of dry and wet zoning, and it will easily cause inconvenience. Be careful, never use the slide, because the water and dust in the slide are difficult to clean, and it will stink after a long time.

3. Before making the bathroom glass partition, first lay the floor tiles and wall tiles, and then customize the bathroom glass partition according to the actual size. It should be noted that there may be errors in the wall surface, and the glass door should be installed and used according to the actual size.

4. Attention should also be paid to the glass partition of the bathroom. Glass doors with doorframes can block water. If there is no doorframe, the doorsill should be specially installed, which is generally 1.5 cm ~2 cm above the ground, otherwise the shower water will not achieve the purpose of dry and wet partition.

4. A handle should be installed beside the bathtub. The bathtub in the bathroom is a place where the whole family needs to take a bath. There are water, shower gel and other risk factors that are easy to slide down in the bathroom. Therefore, in order to ensure safety, it is best to install a hand lever next to the bathtub, especially for the elderly and children at home, and pay more attention to this detail.

I believe that through the installation steps of the bathroom shower glass partition above Bian Xiao. This paper also introduces the matters needing attention in installing shower glass partition in the bathroom, hoping to help friends who want to install shower glass partition in the bathroom.