How to fold a three-dimensional elephant

Step/method of a square piece of pap

1 Prepare a square piece of paper, with the white side facing up, and unfold it after the four corners are folded in half, leaving a diagonal line.

Fold both sides of the paper diagonally.

Turn the paper over and fold the sharp corners to the top.

Turn the paper over again, open it from under the paper in the upper left corner and fold it diagonally. Repeat the action on the right to get this shape.

5 spread and flatten from the middle of the two big corners of the paper.

6 Fold the paper diagonally.

Fold the top of the sharp horn outward to make the elephant's tail.

Turn left with two small bends in the shape of rabbit ears.

9 Turn right with two small bends in the shape of rabbit ears.

10 Fold the right sharp corner downward along the middle vertical crease, leaving a clear crease and unfolding it.

1 1 Fold the left sharp corner upward so that the top vertex is aligned with the bisector of the sharp corner, and then open it.

12 opens from the middle of the upper two layers of paper at the sharp corner, folds inward along the new crease, and folds inward.

13 Open the right corner between two layers of paper, turn it outward along the crease just now, and fold it outward.

14 Fold the upper part of the sharp corner along the upper edge of the "rabbit ear" and unfold it.

15 turn inward along the new crease.

16 Fold the lower half of the sharp corner upward, and the tip will exceed the top of the paper by about 3 mm, and unfold to get a crease.

17 Fold the small corner of the outer layer along the top edge of the paper, and fold it inward along the crease after unfolding. The reverse is also true.

Do another eversion along the new crease.

19 Fold the "rabbit ear" along the connecting line between the upper and lower points to make the elephant's front leg. The reverse is also true.

Fold the folded paper layer to the right to make the elephant's ears.

2 1 Open the left sharp corner between two layers of paper and flatten it down to make the elephant's face.

Where the paper layer on the left side of the elephant's face becomes thinner, fold the sharp corner on the left side down, approximately parallel to the front leg.

Then spread it out and turn it inside out to make an elephant's nose.

Open it between the two layers of paper above the nose and fold both sides outward to make the nose thinner.

Make an inside fold at the tip of the nose, and then make an outside fold to make the alar upturned.

Fold the tip of the paper on the front leg up, leave a crease and turn it inside out. The reverse is also true.

Fold the back leg according to the length of the front leg and turn it inward along the crease. Note that the lower edges of the front and rear legs are on the same plane.

Fold the back of the hind leg at a small angle, open it and turn it inward to make the hind leg thinner.

Gently open the elephant's body from the back and abdomen to make it three-dimensional and stable.

For more information, please refer to.

/article/6b 97984d 6769 c 1 1 ca 2 b 0 bfbb . html