What kinds of washbasins are there?

There are many varieties of washbasins, generally including the following varieties:

I. Angle washbasin

Because the angle washbasin occupies a small area, it is generally suitable for a relatively small bathroom, which is equipped with a bathroom after installation.

Second, the ordinary washbasin

Suitable for general bathrooms, economical and practical, but not beautiful.

Third, the vertical washbasin

Suitable for small-scale toilets. Can be matched with high-grade interior decoration and other luxury sanitary wares.

Four, along the desktop and along the desktop washbasin, etc.

Suitable for high-grade bathrooms with large space decoration, with marble or granite countertops.

There are generally three kinds of holes in washbasin, namely, water inlet hole, overflow prevention hole and drainage hole. In order to fill the washbasin with water, the drain hole must be blocked, and the drain hole is usually equipped with a special plug. Some plugs can be removed or closed directly, while others are controlled by the pull rod on the bathroom faucet.

According to the number of water inlet holes of washbasin, washbasin is divided into non-hole, single hole and three holes.

The faucet of non-porous washbasin should be installed on the porch table or the back wall of washbasin; The hot and cold water pipes of the single-hole washbasin are connected to a single faucet through a hole, and there is a threaded opening under the faucet, which is fixed on that hole with bolts and nuts; A three-hole washbasin can be equipped with a single double-hole faucet, or with double hot and cold faucets. The cold and hot water pipes are respectively connected to both ends of the faucet through bell mouths left on both sides, and the washer of the faucet is screwed with nuts and fixed with the washbasin.

2 How high is the washbasin?

There are many factors that determine the height of washbasins installed in bedrooms and bathrooms. Manufacturers generally calculate according to the average height of family members, so the height of washbasin is not a harsh condition. The most basic factor that determines the washbasin is to make consumers or users feel comfortable and convenient to use. According to the experience of most users, the general standard height is about 80 cm from the washbasin table to the washing machine floor, so everyone can float up and down according to this standard when decorating at home.

Although the height of the washbasin is not very noticeable, its function can not be ignored, because it is inconvenient to use if the washbasin is too high, and it is easy to make people stand with a sore waist when it is too low. Especially when hanging washbasin, users must pay attention to the height of washbasin, so generally speaking, the owner has no special requirements for the height of washbasin, so when installing, the height of pool surface or countertop should be kept between 80-85 cm.

Because of the height factor, some owners need to adjust the height of the washbasin, because the height of the conventional washbasin is not suitable for us to use. What is the height of the washbasin in the bathroom in this case? Just pay attention to one principle: it is also appropriate to keep the height of the washbasin in the bathroom at about half the height of the user himself. This product makes people more comfortable to use.

3 washbasin model specification size

First, the size of the angular washbasin

Angle washbasin covers a small area, the general angle washbasin is 650 mm and 450 mm, which is also suitable for smaller toilets. After installation, the bathroom will have.

Second, the size of the ordinary washbasin

Ordinary washbasin is 600 mm and 400 mm in size, which is suitable for ordinary toilets. Economical and practical, but not beautiful.

Third, the size of the desktop washbasin

The size of the desktop washbasin is 750 mm and 450 mm, which is suitable for small toilets. Can be matched with high-grade interior decoration and other luxury sanitary wares.

Four, along the cabinet washbasin and non-along the table washbasin.

There are 900 mm and 650 mm washbasins along the table and not along the table, which are suitable for bathrooms with high decoration in large space. The countertop is made of marble or granite.

There are generally three kinds of holes in washbasin, namely, water inlet hole, overflow prevention hole and drainage hole. In order to fill the washbasin with water, the drain hole must be blocked, and the drain hole is usually equipped with a special plug. Some plugs can be removed or closed directly, while others are controlled by the pull rod on the bathroom faucet.

At present, the commonly used washbasins are: 585×390mm, 600×460mm, 700×460mm, 750×460mm, 800×460mm, 900×460mm, 1000×460mm and 600× 405×/kl. In order to meet everyone's housing needs, merchants had to quit many washbasins of different sizes with the same brand, and finally this happened.

4 washbasin installation process and matters needing attention

Walsh ball installation process

1. Before installation, check whether the basin body and water outlet are flat.

2. Install rubber gaskets inside and outside when falling into the water. It is forbidden to use plastic silica gel as gasket. The fixing screws should not be tightened too tightly to avoid deformation of the seat cushion. The overflow hole should be aligned with the basin water hole.

3. Plastic scraper or rubber shall be applied between the faucet and the basin surface to prevent the basin from being deformed and damaged due to hard contact.

4. Three-dimensional washbasin must be installed and positioned.

5. Fix the column. The pot body is fixed with galvanized bolts with a diameter of 6mm and rubber pads with a thickness of1.5mm.. ..

6. Joints between column and floor, floor and basin, basin and wall shall be sealed with high-quality and efficient mildew-proof silicone sealants.

7. It is forbidden to connect the short falling water and drainage system with plastic hose, and it should be equipped with water-bearing elbow. The joint must be sealed to effectively prevent sewage from overflowing.

8. Expansion bolts should not be used to fix the washbasin and the wall, and Y-shaped nylon pipes should be used.

9. After the installation is completed, conduct a 2-hour pressure test to observe whether there is overflow.

10, the upper and lower pots must be evenly sealed with high-quality mildew-proof silicone sealants during installation.

Precautions for installation of washbasin bracket

Depth is proportional to strength.

Let water splash on your body, which is probably the most uncomfortable thing for people. Conventionally, the depth of the washbasin is directly proportional to the water flow density installed above the faucet, that is, the faucet with strong water flow can only be installed in a deep washbasin. Never install a coarse faucet on a shallow pool, which will make people splash when using water. It's better to have enough curvature at the bottom of the pool, and it can't be peaceful, otherwise there will be water on it.

Pay attention to the height

Whether it is a suspended or vertical washbasin, the height of the basin surface or countertop from the ground should be 80 to 85 cm. Too short a pool will make people feel backache.

Spatial decision-making form

Wash basins are roughly divided into two types: independent and desktop. Free-standing style is beautiful, occupies a small area, and is convenient to use and maintain, which is suitable for small toilets. However, a mirror box or bath stand is needed, so that some toiletries or cosmetics can be placed beside the pool. The desktop washbasin should occupy at least one small table. Washing tools can be placed on its countertop, and sundries can also be placed in the cabinet below. If the bathroom area is not large, only consider installing a triangular washbasin in the corner, and hanging a triangular glove rack above the washbasin can consider placing toiletries.

Don't install the washbasin in the bathroom at will. If the height of the washbasin is appropriate, it will be natural, comfortable and just right. Some washbasins are inconvenient to use because they are not suitable in height, or stand too low and have a backache, or stand too high and are inconvenient to use.

5 stainless steel washbasin purchase skills

1, space determines form

Face basins can be roughly divided into two types: freestanding and desktop. Free-standing style is beautiful, occupies a small area, and is convenient to use and maintain, which is suitable for small toilets. However, a mirror box or bath stand is needed, so that some toiletries or cosmetics can be placed in the space above the basin. The cupboard washbasin should occupy at least one small table space. Washing tools can be placed on its countertop, and sundries can also be placed in the cabinet below. If the bathroom area is not large, you can choose to install a triangular washbasin in the corner, and a triangular debris rack can be hung on the washbasin to place toiletries.

Step 2 pay attention to the height

Whether hanging pots or standing pots, the height of the pot surface or desktop from the ground should be 80-85 cm. Too short pots will make people feel backache.

Step 3 pay attention to smoothness

The basin edge of the basin must be slightly lower than the countertop, but the joint with the countertop must be smooth, so that the water splashed on the countertop can flow back to the basin unimpeded and facilitate the cleaning of the countertop. The sink table must be made of smooth materials, and the edges and corners must be smooth to avoid bumping. The wear resistance of the basin is usually very important. For the basin surface with high smoothness, it is difficult for impurities in water to adhere to the surface, which reduces the cleaning times.