Traditional Culture Encyclopedia - Hotel franchise - How to use the mite remover

How to use the mite remover

Lead: In recent years, people began to like to use mites to make simple plots for their bedding, so how should they use them? Let's get to know it together!

It takes us at least one hour to finish the three cleaning processes of bask in the quilt sheets, patting quilt sheets and using a common vacuum cleaner, which takes a lot of time and manpower, and the acaricidal rate is only 3.8%. Using the special I- cleaning mite remover, the workload is only one quarter of the previous one, and the time is also reduced to one tenth of the original one, but the effect is actually 30 times that of the original one. Because this bed-specific mite-removing vacuum cleaner can be used for sterilization and disinfection of mites in all families, as a tool for ultraviolet sterilization and disinfection, it can be used in hotels and ordinary hotels, and its mite-removing effect is very effective.

Steps for using acaricide 1

Plug the power plug into the socket.

2

Press the function selection key (the largest key at the top) and the display light will light up. At this point, the dust removal function is enabled.

three

Press the function selection button and touch the button. At this time, at the speed of 8600 rpm, the dust mites on the surface and deep layer of the mattress, their bodies and excreta are effectively cleaned. Brand-new triple deep cleaning system, comprehensive care for health.

four

Press the function key uv key, and then it will emit ultraviolet light and ultraviolet light, quickly killing mite bacteria and harmful bacteria.

Comparison method of acaricide effect 1: sun exposure

An extreme experiment was done to reduce the quilt in equal proportion, and 654.38+ ten thousand live mites were poured into the gap of the quilt.

Exposure to the sun for 4 hours in winter found that only about 60% of mites could be killed.

Moreover, we have done experiments before, and even if exposed to the high temperature of 39 degrees in summer for 4 hours, mites still survive.

In addition, the quilt can be dried frequently, but the mattress with the most mites can't be taken out to dry.

Therefore, sunbathing is not a good way to eliminate allergens.

Method 2: Ultraviolet irradiation

We have done a limit test, using 30 watts of medical ultraviolet light to directly irradiate dust mites at close range for 2 hours.

The results showed that the dust mites were still alive and kicking under ultraviolet radiation.

Moreover, this is still direct irradiation. If it is irradiated on a quilt or mattress, don't say that irradiation can't kill mites. All mites can run, but they can't find them in the depths of the mattress.

Therefore, ultraviolet irradiation is not an ideal method to eliminate mites.

Method 3: Mite control instrument

In actual measurement, professional mites can adsorb allergens on sheets and bedding.

However, the pumping effect is very different.

We bought three different brands of mites at random from the market and measured the effect.

The experimental site is an express hotel with three rooms. Three beds in the room were tested with three different brands of mites.

A * * * opened three rooms and conducted three sets of tests. The results show that the suction of the three mites is very different.

Among them, green acaricide has better effect, followed by white and red.

Experiments show that acaricides are effective in removing dust mite allergens, but not all acaricides are effective? Is it also effective for deep mite allergens? We will upgrade the experiment.

The experimenter bought a Simmons mattress that had been used for many years in a small hotel.

You can tell by the color that this is a mattress with a story.

Whatever. If you cut the mattress open, you can see that it consists of palm cushions, two layers of sponges and two layers of cloth.

Cut off three mattresses with the same size as the sample, sprinkle the same number of live mites on the palm mat at the bottom, cover with two layers of sponge and cloth, and suck out mites from the surface for 3 minutes with three kinds of mites eliminators to see how many mites can be sucked out.

Red mite scavenger:

Only the marked dirty things can be sucked, and the mites at the bottom of the mattress and the dead skin of people can hardly be sucked up.

White acaricide:

The effect is slightly better than that of red acaricide. Some mites are sucked into the interlayer, but they are not completely sucked away.

Green acaricide:

In use, I feel that the suction of this machine is stronger and the final effect is better. Basically, the mites at the bottom have been sucked away, and the sponge interlayer is relatively clean.

The three samples are observed under the microscope, and the difference is also quite big.

The green mite remover is relatively clean to absorb, and there is basically no residue on the mattress.

White acaricide, some dead skin and dust mites are stuck in the sponge layer of the mattress.

Almost all the red acaricide remains at the bottom of the mattress, and it has almost no adsorption capacity for deep allergens.

Therefore, strong inhalation is an effective method to control mites and allergens from the root.

Of course, judging the quality of a mite remover, besides suction, there is also an important factor: the quality of the filtration system.

Because dust mites are very small, they can easily spread out from vents, causing secondary pollution.

Therefore, a good mite remover will be equipped with a better quality filtration system.

Experimental conclusion

1, cleaning the quilt can not completely remove allergens, because the place with the most mites is the mattress;

2. Traditional sunlight and ultraviolet radiation can't completely kill mites;

3. The effect of different brands of mites is very different. Besides the suction, the quality of the filtration system is also a very important factor.