How to check the quality of glass partition?

[Jane's High Compartment Network] Non-load-bearing interior walls are called partition walls (dead partition walls). The basic requirement of partition wall is that its own mass is small to reduce the load on floor and floor, and its thickness is thin to increase the usable area of the building; And sound insulation, waterproof, fire prevention, etc. According to the specific environmental requirements. Considering that the separation of rooms changes with the change of use requirements, the partition wall should be dismantled as easily as possible. Generally speaking, our quality monitoring methods for glass partitions with simple compartments are as follows.

1, the variety, specification, performance, pattern and color of the materials used in the glass partition wall project should meet the design requirements. The glass partition wall shall be made of safety glass.

Observe and check the product certificate, entry acceptance record and performance test report.

2. The masonry of glass brick partition wall or the installation method of glass plate partition wall should meet the design requirements.

Observe and check.

3. The Rachel reinforcement embedded in the glass brick partition masonry must be firmly connected with the matrix structure and in the correct position.

Check with hands and feet, and check the acceptance records of concealed works.

4. The glass partition device must be firm. Glass partition rubber pad device should be correct.

Observe, push and check the construction records.

General project

1, the appearance of glass partition wall should be uniform in color, flat and clean, clear and beautiful.

Observe and check.

2. The joints of glass partition walls should be horizontal and vertical, and the glass should be free of cracks, defects and scratches.

Observe and check.

3. The sealing of glass partition wall and the pointing of glass brick partition wall should be dense, flat, uniform, straight and consistent in depth.

Observe and check.

4. Inspection method of allowable deviation of glass partition device.

Check the verticality of 1 facade with 2m vertical measuring ruler.

2 appearance flatness, with 2m by feet and feeler check.

The angle of yin and yang is square, so check it with a right-angle measuring ruler.

4. Seam straightness, draw 5m lines, and check the lack of 5m lines with a steel ruler.

5 joint height difference, check with steel ruler and feeler gauge.

6. Seam width, check with a steel ruler.