How to install a toilet in the bathroom?

Installation methods of conventional toilets:

1. Before installation, remove the pipe plug from the ground drain, carefully check whether there is any debris in the pipe, and then clean around the pipe mouth.

2. Make sure that the floor where the toilet is installed is hard and flat, and cannot be paved with floor tiles or other decorative materials. If there is sand and gravel, it must be cleaned up.

3. Before fixing the toilet, make sure it is level. It is recommended to use a spirit level to calibrate it.

4. Fix the toilet.

5. Remove the sealant adhered during construction. It must be removed in time while it is still wet to avoid being difficult to remove after it dries.

6. Connect the water inlet pipe and make sure it does not leak.

7. After about an hour after installation, test flush several times to ensure that the sewage pipe is unobstructed. To test the sewage discharge effect of the toilet, the method is to install the accessories in the water tank, fill it with water, put a piece of toilet paper in the toilet and drop a drop of ink. If it can be discharged at once without leaving any trace, it means the water is flowing smoothly.

8. Please note that the toilet must not be used within three days after installation to avoid affecting its stability.