What are the procedures and steps of making a bed in a hotel room?

Laying method of plate: first positioning: one-time accurate positioning; Do not deviate from the center line; Raise your head. The first angle: the four angles are consistent in style and angle; The corners shall be smooth and tight, and the points on both sides of the bed shall be not less than15cm; ; The part of the bed head and the end of the bed tucked into the mattress shall not be less than 15cm. . The second time, positioning; Once in place; Don't deviate from the centerline, face down. Blanket throwing positioning: once in place; Do not deviate from the center line; The blanket trademark is at the lower right; Cover a small part of the blanket with a sheet; The distance between the blanket and the bed is 25 cm. The second angle; The styles and angles of the two corners are the same; The two wrapping angles are even and tight, and the parts stuffed into mattresses on both sides of the bed are not less than15cm; ; The end of the bed shall not be less than 15cm.

Pillowcase method: pillowcase: full corners, flat and crisp appearance; The pillow core is not exposed. Put pillows: the distance is equal to both sides of the bed, and the opening of the pillow faces the bedside table in the middle.

Laying method of bedspread: Laying bedspread: The bedspread is neat and beautiful, and the bedspread overlaps with the edge of mattress; The bedspread has no pillows and no white edges, and the redundant part of the bedspread is stuck between the two pillows and the bottom; The two corners at the end of the bed are vertical and stiff.

First, pull out the mattress below: bend down, raise the mattress slightly with both hands and pull it out slowly. Check the pads and clean your hair in time. A protective pad is paved, and four corner fixing belts are sleeved on the mattress; If stains are found on the protective pad, replace it in time. ?

Secondly, spread the sheets: stand outside the bed and shake the sheets. The center line of the sheet is aligned with the center line of the bed, and both sides of the sheet are flat. Check the sheets and clean your hair in time. If the sheets are found to be damaged, stained or wrinkled, they should be replaced in time. Straighten the sheets and wrap the inner corners first. The inner corner does not require degrees, but it needs to be tucked under the mattress.

Then reset the mattress: bend down and slowly push the mattress under the headboard. Don't push too hard. ? There are two corners outside the bag. The wrap angle requires an inner angle of 45 degrees and an outer angle of 90 degrees. The four corners are tightly wrapped and all the four corners are tucked under the mattress.

Then cover the quilt: shake off the quilt cover and check for damage and stains. Put the quilt evenly into the quilt cover, and position the four corners accurately; Outside the bed.

Secondly, a set of pillows: shake the pillow core loosely and lay it flat on the bed. Grab the front ends of the pillow core and stuff it into the pillowcase and put it away. Grasp the bag mouth with both hands and shake it while lifting it, so that all the pillow cores enter the pillowcase. Insert the pillow core into both sides of the pillow bag, tidy the mouth of the bag and pat it loose. Pillows must have full corners, flat and crisp appearance, and the pillow core is not exposed. ?

Then spread the upper bed sheet: stand on the outside of the lower bed, shake the bed sheet, first spread the bed sheet, take off your shoes and climb onto the upper bed. Check the pads and clean your hair in time. If the sheets are found to be damaged, stained or wrinkled, they should be replaced in time. Kneel on the bed, lift the mattress slightly by hand, wrap the two corners of the bed first, flatten the sheets, and then wrap the two corners of the bed. Draw the window screen and pull the curtain neatly to one side. Windows can be closed according to the external environment and weather. And pay attention to check whether there is any stain on the curtain and whether the curtain hook falls off.

Then spread the quilt: flatten the quilt, fold it longer than the bed, and stack it against the wall and the bedside.

Finally, put pillows: put two pillows in the middle of the bed and lay them flat on the bed. The openings of the two pillows are opposite.