Kesler maintenance and common faults

With the improvement of people's living standards, most families now use massage chairs, foot baths, neck and shoulder massagers and other massage appliances! Using these massage appliances can effectively relieve fatigue and release stress. Kesler is a well-known brand in the world that specializes in the production of massage appliances, foot baths, etc., and is the choice of many people. So, will everyone use these massagers and will they need to repair them? Let’s take Kesler as an example to talk about the common faults and repair methods of these massage appliances.

The Kesler massage chair will have problems such as the massage wheel on the back not moving up and down, and crashes when starting up. When these failures occur, we can take the following maintenance measures: The back massage wheel cannot move up and down because the power export belt at the motor responsible for lifting is soaked in leaked engine oil and appears to be slipping. Take it off and clean it with detergent. Just wipe dry. If the machine crashes, you need to forcefully rotate the lifting screw. Move the massage machine to the middle position and correct the deformed reed. At the same time, consider contacting the manufacturer to request a new stroke control switch. Some light-sensitive switches may fall into dust after long-term operation. Try wiping them clean with your face to remove them.

The Kesler footbath will have common faults such as not heating, not spraying water, not vibrating or making abnormal sounds. At this time, you can address these faults: Use a multimeter to connect the resistance dial to both ends of the heating tube to see the effective resistance. If there is no resistance value displayed, the heating tube is broken. Replace the heating tube to troubleshoot. If the fault still exists after the above treatment, you can check the driver board heating. Replace the transistor 8050 with 8050 next to the relay and check the sensor connection; replace the water pump; replace the vibration motor and the fault can be eliminated.

Common faults of Kesler neck and shoulder music include: no vibration; failure to adjust the vibration intensity; the motor operates normally but does not vibrate; abnormal noises are made during use, etc. We need to take the following solutions: insert the plug or switch with poor contact, replace the broken motor or close the open coil; replace the bad strength switch, close the open lead, replace the damaged rectifier diode; the eccentric hammer falls off, just reinstall it . Adjust the distance between the fixed iron core and the movable iron core that is too close; replace the damaged or missing rubber pad between the two iron cores.

The above is the maintenance of Kesler Massage. In fact, Kesler massagers also include pedicure machines, spine massagers, etc. The most common faults of these massagers are similar. When we use Kesler massagers, if the above conditions occur, we can try to use these methods to repair them. . However, the massager cannot be used at any time. You must pay attention to situations such as extreme fatigue, illness, half an hour after a meal, hunger, etc. Do not get a full body massage as this can cause damage to the body.