How to use the bedside button in Orange Hotel?

After the guests register at the front desk, the front desk will automatically connect to the network to start the room equipment, and automatically run the room equipment to the welcome mode according to the hotel service requirements, such as automatically selecting the lighting state, temperature air conditioning operation mode and so on. When the guest completes the registration and goes upstairs to the room, all the equipment in the room has been adjusted to achieve the welcome effect.

When the guest checks in, the right to open and manage the room equipment is given to the guest. The front desk can carry out remote monitoring in real time.

4.2 Description of main modules of guest room control

① Intelligent power taking

When the guest enters the room, he only needs to swipe the key card to open the door. The door lock and infrared detector can transmit the entry signal to RCU, which can judge whether it has entered the door, and then power on the socket to enter the welcome mode. When the guest leaves the store, the infrared detector and the door lock will send a departure signal to the RCU, and the RCU will turn off the power after comprehensive judgment.

① bedside control panel

A touch panel is installed on the left and right sides of the bed, which can control the switch of room lights, room lights and night lights. , you can also control the total on/off of room lights.

The ordinary control panel is connected to the system through an interface, and the function of each button on the panel is defined by a preset program, which can realize the requirement that one button can complete multiple functions and reduce the cost.

In order to avoid the trouble of turning off the lights, stereo and TV when guests sleep, a "sleep" is set up.

Switch, when the guest falls asleep, just press the "Sleep" button, all the lights in the room will go out, and the controller will enter the night service program. At this time, it is the night light switch. Press the sleep switch again to turn on/off the night light. while

When other lights are turned on, it will automatically exit the sleep mode.

② Temperature control

A series of temperature control panels are installed on the side wall to automatically control the constant temperature of the fan coil in the guest room.

The temperature control panel has a large display screen, which can simultaneously display indoor temperature, cooling/heating mode, wind speed, day of the week, etc. When the temperature is adjusted manually, the LCD will display the set temperature.

The temperature control panel can be used to set the temperature of the fan coil. Manually adjust the set temperature or automatically set the temperature. The built-in temperature sensor can sense the indoor temperature, and the LED on the panel gives corresponding instructions, including room temperature display, cooling/heating status and so on. You can manually select the hot and cold and high/medium/low speed of the fan. Guests only need to adjust the temperature according to their own preferences, which is convenient to operate.

The temperature control panel is connected with the system through the bus to realize the networked control of room temperature. This design automatically sets three temperature modes on the temperature control panel (taking summer as an example):

Unsold mode: when the guest is at the front desk after checking out, the set temperature is automatically adjusted to 30 degrees.

Energy-saving mode: when guests check in at the front desk or pull out the power card, the set temperature is automatically adjusted to 26 degrees.

Check-in mode: When guests swipe their cards into the room or plug in their cards to get electricity, the set temperature will be automatically adjusted to 22 degrees.

The set temperature of these three modes can be connected with each other, and the temperature can be reduced in stages, which will not affect the comfort and save energy.