What should I do if the shower is used for a long time and the water is small?

1. Is the tap water pressure at home lower than before? If yes, you need to find a water company to check the water supply pipeline and pressure.

2. The pipeline valve connected with the water heater is slightly opened: the water inlet valve is opened.

3. Because the living floor is high and the water pressure of the water source is low, the water output will be smaller after decompression through the mixing valve. At this time, it is suggested to connect 1 booster pump in series between the water supply valve and the water inlet of the water heater.

4. The water mixing valve is inherently insufficient, with small diameter, and the water output is reduced by throttling: the water inlet end of the water mixing valve can be disassembled and connected to the water supply valve of the water heater with a hose, or the hose of the nozzle can be directly connected to the hot water outlet end of the water heater, and the quality of the water mixing valve can be judged according to the water output of the nozzle; Under the condition of meeting the water pressure of the water source, the Zheng Zhuang brand water mixing valve can be replaced.

5. Improper installation, deformation of rubber ring, uneven or thin outlet pipe joint, mismatch between hose and shower head, etc. Select the appropriate hose and shower head according to the specifications, replace the rubber ring and reinstall it.

6. The nozzle is congenitally insufficient, and the internal resistance is large, resulting in small water output: change the nozzle.

7. The shower pipe is broken, and the pipe can't flow out because of blockage: Chinese medicine maintains the water pipe well during use, which not only affects the appearance, but also easily leaks after repeated discounts.

8. The nozzle is blocked, resulting in poor water outlet. 1 If the water at home is too alkaline and contains some impurities, it is easy to block the shower hole; In addition, air sediment dust will also enter the interior through the small holes of the shower head, which will also block the shower head for a long time; Improper conditioning of shower heads may also lead to an increase in foreign body scale.

We can rotate and adjust 1 lower nozzle; After removing the nozzle, turn the nozzle of the nozzle upward, find a soft object of 1 and tap it gently to shake off the congested gravel. At the same time, clean the nozzle of 1, then clean it repeatedly with clear water, and then put it back. Or go to the supermarket to buy 1 bottle of detergent and remove the shower head. Put it on water and clean it with detergent. It will be faster to clean it with warm water like 1. After washing, be sure to clean the residual detergent on the nozzle, and then install the nozzle as it is. You can also use vinegar (rice vinegar) to soak the shower head in vinegar. Be sure to soak all the holes in vinegar. Wait 10 minutes to take it out, then rinse off the residual vinegar in the shower head with clear water, and then put the shower head back on the shower panel. If the blockage is serious, you can boil vinegar first and then soak it, but it should be noted that boiling vinegar is limited to metal showers, and plastic showers should be soaked in cold vinegar.

Besides, if your shower head is fixed on the wall, you can't take it down and soak it in vinegar. You can wrap the nozzle in a plastic bag filled with vinegar, stick it with adhesive tape, then let it stand for 1 night, and then take off the vinegar bag the next morning. But be careful not to stick the tape on the circuit board or paint.

At the same time, be careful not to use strong acid when descaling, so as not to corrode the surface of shower nozzle.