Who installed the lock of Bentley Hotel?

A, intelligent door lock installation instructions

1. Prepare the installation tools for the door lock: hammer, flat chisel, ruler, Phillips screwdriver, 5mm hexagon screwdriver (optional), 2mm hexagon screwdriver (optional), electric drill and electric drill.

2. Identify the direction of the door lock

1, right (r) door lock: The door hinge (door knob) located on the right door frame is the right door lock.

2. Left (L) door lock: The door hinge (door button) located on the left door frame is the left door lock.

3. For keyhole excavation, refer to the opening template.

4. Install smart door locks

Installing lock core

1. Remove the side trim panel first.

2. Fix the lock core on the door with two cross countersunk wood screws, and be careful not to press the wire during installation.

3. Install the side trim panel

Installing front and rear panels

1. First install the lock on the front panel, and try whether the mechanical key is smooth (take out the mechanical key after the test, and then proceed to the following installation steps).

2. Install the square shaft inside and outside the door

3. Connect the 8-pin data cable between the front panel and the lock cylinder.

4. Connect the battery cable.

5. Install the front and rear panels and fix them with hexagon countersunk head screws (panels). Pay attention to the data cable, don't press it.

6. After installing the battery, debug the door lock to ensure that the oblique tongue and the square tongue pop up freely; The mechanical key can open the door normally;

Smooth rotation of the handle, etc.