How to install the reversing image of truck rearview mirror

1. First, remove the power supply connection at the vehicle battery, and put the removed connection away from the electrode to prevent the power supply from being connected by mistake. 2. Determine the installation position of the car camera. There are generally two kinds: one is installed on the license plate light, which is relatively easy. Just use the small screws provided in the camera accessories to fix the camera on the license plate light. Adjust the iron plate or gasket in the accessories to make the camera reach the best reversing angle. 3. The line of the camera penetrates into the car through the gap of the license plate lamp, and is connected with the backup lamp power supply and the video extension cable. This kind of mounted backup camera is a popular one at present, which is more hidden in appearance and easier to install. 4. Connect the power cord of the camera with the power cord of the backup lamp. Then connect the video cable of the camera with the video extension cable, and the other end of the video extension cable is connected with the AV input of the vehicle monitor. Finally, restore the battery power supply, start the car, hang the reverse gear, and you can see the reversing image on the car display screen. Note: 1. You can't rely entirely on the rear view system when reversing, you can only use it as an auxiliary tool for reversing. 2. The vehicle monitor must be connected correctly. If the monitor does not provide an AV input interface, you must find the corresponding video cable or install a video switching device to display the rear view image normally. 3. Don't easily connect the power supply of vehicle-mounted electrical appliances directly to the power supply of vehicle-mounted batteries, so as not to cause power instability. 4. Some German cars and American cars are equipped with reversing images, which will shake the picture. For solutions, please visit our "communication area".