Background problem of tent shooting

1. The camera is too high. When shooting trousers, put the lens height below the model's knee to show the leg length. Try to lie down or squat. In addition, stand farther away and try to shoot with a longer focal length.

There is nothing wrong with the paper, but the light on the paper is too messy. You should let the model stand as far away from the background as possible, and adjust the angle of the light, so that the light shining on the model should not shine on the background as far as possible, and the light in the background should be adjusted by the light alone. This is the principle of independent lighting. You can judge the distance between the model and the background by carefully looking at the left and right pictures and paying attention to the shadows.

3. The light is OK, which is totally enough. The unevenness of the background paper is a light problem, not a lamp problem. The equipment in your hand is good, which should be regarded as a slightly luxurious level abroad. Shoot as much as possible, observe carefully, and don't easily doubt that the equipment is not good enough.

The photos in your question supplement keep people away from the background. Put a lamp on the side and back of the model, and install a lamp tube (also called pig mouth) to make a bright spot in the middle of the background. The background of most portrait photos is separated from the lighting of the model, which keeps the model away from the background and the two sets of lighting do not interfere with each other.

In addition, all the advertising photos are retouched, and the original film may have some defects, such as a wrinkle on the background paper and a shoe print on the ground, all of which have been repaired. Try to be perfect when shooting, but don't compare it with printed commercial films. There is still a process.