Traditional Culture Encyclopedia - Photography major - High score for holga 120 gcfn novice tutorial! ! ! !
High score for holga 120 gcfn novice tutorial! ! ! !
Model 120FN built-in flash
Model 120CFN color chip with built-in flash camera
catalogue
1. Camera description
Film coating
3. Set the number of sheets per volume.
4. Install the battery (120FN and 120CFN only)
Load film
be concentrated
7. Set the aperture
shoot
9.b-door exposure
10. Multiple exposure
1 1. unload the film.
12. Use the built-in flash (limited to 120FN and 120CFN).
12. 1 How to use the flash (120FN and 120CFN only)
12.2 Select the flash color (limited to 120CFN)
13. Some simple suggestions
14. Specification
15. Optional accessories-color filter and special effect mirror
15. 1 color filter
15.2 hollow soft mirror
15.3 Multi-lens
explain
1. Camera description
(1) "b" door switch
(2) tripod connecting seat
(3) lens
(4) focusing ring
(5) Louvers
(6) Slicing knob
(7) Flash color selection dial (limited to 120CFN)
(8) Built-in flash (120FN and 120CFN only)
(9) viewfinder
(10) Aperture setting button
(1 1) paper/film number setter
(12) Rear lid lock pin
(13) viewfinder eyepiece
(14) flash indicator (120FN and 120CFN only)
(15) Flash switch (120FN and 120CFN only)
(16) Rear cover
(17) Red window at the counter
(18) paper size frame
Film coating
This machine can use all 120 films. It is recommended to use 100 degree film on sunny days and 400 degree film indoors on cloudy days.
3. Set the number of sheets per volume.
This machine has two frame sizes-one is used to shoot 65,438+066x4.5cm film, and the other is used to shoot 65,438+026x6cm film. These two frames are marked with "16" and "12" for easy identification. The steps to set the paper size and the number of sheets per roll are as follows:
(a) Press the pin locks on both sides of the back cover to remove the back cover.
(b) Take down the original picture frame inside and put it into the picture frame corresponding to the number of pictures to be taken in each roll.
(c) Turn the film number setter on the back cover so that the arrow points to the number corresponding to the loaded film frame. At this time, the counter window is also set.
(d) Reinstall the rear cover and push the pins on both sides.
4. Install the battery (120FN and 120CFN only)
The built-in flash requires two 5th batteries, and the installation steps are as follows:
(a) Press the pin locks on both sides of the back cover to remove the back cover.
(b) Remove the frame.
(c) Load the battery according to the positive and negative poles marked on the battery box.
(d) Replace the frame and the back cover.
Load film
(a) Press the pin locks on both sides of the back cover to remove the back cover.
(b) Tear off the seal on the film.
(c) The film cassette is on the left side of the camera. First, fasten the hole at the top of the film into the top of the film cassette, and then push the film into the cassette. The back end of the film should point to the empty reel on the right.
(d) Hold the film with your thumb and pull out the backing paper about 10 cm.
(e) Insert the tail end of the film backing paper into the seam in the middle of the right blank film shaft, and turn the film-passing knob to fix the backing paper.
(f) Reinstall the rear cover and push the pins on both sides.
(g) Turn the winding knob until "1" appears in the red window of the counter.
(h) Now we are ready to shoot.
be concentrated
Although this machine is a fixed focal length camera, it still offers four object distance options. There are four symbols on the focus ring, as shown below:
(1) single person = 1m
Three people = 2 meters.
Many people = 6 million
(d) Distant mountain = 10/0m
You can set a more precise distance between two symbols.
7. Set the aperture
There are two kinds of apertures to choose from, as follows:
(a) Clear-day symbol = f/ 1 1, which is selected on a clear day.
(b) Choose cloudy symbol = f/8 on cloudy days.
shoot
(a) Set the aperture according to the weather and ambient light intensity.
(b) Visually check the object distance and rotate the focus ring to a proper position.
(c) Composition through the viewfinder. Tap the shutter to take a picture.
(d) Turn the sliding knob slowly until the next number appears in the red window of the counter. At this point, I am ready to take the next picture.
9. Use B-door exposure
This function can take long exposure photos at night or indoors. The use steps are as follows:
(a) Mount the camera on a tripod. This is to avoid unnecessary shaking during exposure.
(b) Turn the B door switch to "B".
(c) Press and hold the shutter until the required exposure time ends to close the aperture.
(d) Return the B-door switch to the "N" position.
10. Multiple exposure effect
The effect of multiple exposures can be achieved by taking a lens that does not penetrate the film.
Every time you press the shutter, you are exposed. This feature can give full play to the photographer's imagination.
It's easy to achieve multiple exposures-don't cross one film.
1 1. unload the film.
The steps are as follows:
(a) Turn the film-passing knob until there are no more numbers in the red window of the counter, that is, all films have been wound on the correct reel.
(b) Press the pin locks on both sides of the back cover to remove the back cover.
(c) Take out the reel on the right. Wrap the reel tightly and fix the backing paper with adhesive tape to prevent it from loosening. Now, the film can be sent for development.
(d) Take out a new blank roll from the left side and put it on the right side for use when shooting the next roll.
12. Use flash (120FN and 120CFN only)
There are two cameras with built-in flash in this series, namely: 120FN, with flash function as standard; 120CFN with optional color flashing function.
12. 1. How to use the flash (120FN and 120CFN only)
(a) Confirm that it is set to the flashing symbol "".
(b) Turn the flash switch to "ON". When the flash starts charging, you can hear a small sound.
(c) After a few seconds, the flash indicator will light up, which means that the flash is fully charged. If the flashing indicator does not light up within 30 seconds, the battery is about to run out and needs to be replaced.
(d) The flashlight should be turned off when not in use to maintain the power.
12.2. Select the flash color (120CFN only).
There are three colors to choose from, namely red, blue and yellow. White light is used to change the original 5600K color temperature of the flash.
(A) color flash effect
The color flash is similar to the effect of adding a color filter in front of the lens when the flash is not used.
(b) Select the flash color.
There are four letters on the color selection panel of the flash lamp at the top of the machine: "W, R, B, Y"
W = ordinary white light
R = red light
B = blue light
Y = yellow light
Turn the flash color selector to the desired color.
13. Some simple suggestions
(a) Check whether the lens cover has been removed before shooting.
(b) always shoot in the light.
(c) Keep the camera stable at all times.
(d) Always press the shutter gently to avoid shaking.
(e) Shoot immediately after shooting.
(f) Loading and unloading films in the shadows.
(g) Always use the flash in a shadow or dark environment.
(h) Don't shoot objects within 1 meter.
(i) Clean the lens with a soft cloth.
14. Specification
120 model with (120FN and 120CFN)/ without built-in flash (120N).
Lens optical lens, f/8 60mm
Shutter blade shutter, speed1100 second.
Use film 120 color/black and white film, ASA 100/ISO 2 1 or ASA 400/ISO 27.
Viewfinder line of sight is horizontal, paraxial viewfinder
Focus manual
Flash indicator12 (asa100/din21,m) (120FN and 120CFN only)
Flash battery two 5th batteries (120FN and 120CFN only)
Size 140 x 102 x 76 mm
The weight of 200 grams does not include batteries.
Accessories include 1 strap; 2 frames; 1 scroll
15. Optional accessories-color filters with special effects.
Special effects can be obtained by inserting different color filters into the color filter bracket. The following three sets of color filters are available:
15. 1. color filter-changes the color temperature of the subject and background to enhance the artistic effect of the photo. 4 colors of lenses:
Yellow, orange, red, blue
15.2. hollow soft mirror-there is a clear circle in the middle, and the rest have light color and softening effect. 4 colors of lenses:
Blue, red, orange, gray
15.3. Multi-lens -3 kinds of lenses:
Gokage mirror, horizontal three-shadow mirror and triangular three-shadow mirror.
Holga 135 Test results of film rolling problem (turning)
Equipment: official version of holga+original 120 to 135 cassette:
Note: () is the number of rolls, and the number after () is the corresponding number of 35mm films.
Conclusion:
(23) 1-(22)2-(22)3-(22)4-(22)5-(22)6-(2 1)7-(2 1)8-(20)9-(20) 10-(20) 1 1-( 19) 12-( 1 9) 13-( 19 ) 14-( 18) 15-( 18) 16-( 18) 17-( 18) 18-( 17) 1 9-( 17)20-( 17)2 1-( 16)22-( 16)23-( 16)24-( 16)25-( 16)26-( 16)27-( 16)28-( / kloc-0/6)29-( 16)30-( 15)3 1-( 15)32-( 15)33-( 15)34-( 14)35-( 14)36
Because the axis of the coil is getting thicker and the circumference is increasing, the number of coils is decreasing. Roll the film with the above method, and the distance between the two films is 1~2mm.
- Previous article:Black and white portrait photography technology
- Next article:Q: Do you choose 5d2 or HD for wedding photography?
- Related articles
- In Huawei series, how are high-end machines arranged from high-end machines to low-end machines?
- Photography course in technical secondary school
- Mobile phone photography, how to shoot "separation"
- Grab the tail of spring and enjoy food in the holy land in the Roewe RX5.
- Peace Elite: Which game do primary school students like?
- What to wear for marriage certificate photos (let the most important photos in your life leave no regrets)
- Night Wuhan photography
- I want to take a set of outdoor photos. I want to take wedding photos in Guangzhou. Where can I take photos on location?
- Composition of scene description of dragon boat race
- What's the name of Wang Leehom's new album?