How to set the parameters of SLR camera when shooting still life in Canon 550D studio?

First of all, reduce ISO, because the light in the studio is strong, so the sensitivity need not be too high. Pull the lens to the telephoto end of 55, so that the lens is closer and the picture is full. When shooting still life in the studio, it is best to use photometry and bottom light to shoot.

It is recommended to use AV file, that is, automatic file, and the aperture is recommended to be greater than 8 and less than 18. Set to autofocus (AF), and then tap the shutter button to autofocus.

Both tripod and cable release are used for anti-shake to ensure clear picture. Finally, aim at the center of the subject and shoot.

The general lens aperture is 8, and the imaging quality is good. It can't be bigger (that is, the smaller the value) and the depth of field can't be too shallow, otherwise the whole product can't be seen clearly. If the product is large and the depth of field at 8: 00 is not large enough, it can be reduced (that is, increased), which is enough. Don't blindly reduce. If it is too small, there will be a lot of noise, which will affect the picture quality.

Extended data:

The following points should be paid attention to when shooting still life on metal surface with Canon 550d 18-55 lens:

1. Use the 18 terminal to move the camera to the nearest focal length (macro mode);

2, the lens should not be perpendicular to the metal surface;

3. Don't fill the light with a flash;

Step 4 use a tripod.

Baidu encyclopedia canon 550D