How to connect the power cord of led lamp?

We often use LED lights in our daily life, but many people don't know the specific wiring method. So how to connect the power cord of LED lights?

First, how to connect the power cord of the LED lamp?

1. First, set the current limiting resistor to the negative pole of the power line.

2. Separate the positive and negative wires of the LED lamp.

3. Strip the positive and negative wires of the LED lamp with a peeler.

4. Connect the negative wire of the power supply with the positive wire of the LED lamp.

5. Connect the negative wire of LED lamp with current limiting resistor.

6. Wiring is completed.

7. Turn on the lights and see if they can shine.

Second, what aspects should be paid attention to when using LED lights?

1. First of all, we must find a suitable installation site, ensure that there is no corrosive gas in the surrounding environment, and do not put it in a place prone to fire or heavy dust, and also ensure the voltage stability. Otherwise, the ballast will be damaged if it is too large, and the wires connecting the bulbs cannot be added at will, otherwise the bulbs will be damaged. Before installation, we can check the light bulb before installing the mask to avoid rework.

Be careful when storing, and don't open it at will. If it is removed, it should be installed immediately. When placed, it should be stored in a dry and ventilated place with corresponding humidity. When cleaning, it is forbidden to use clean water, and special care agent or alcohol must be prepared, otherwise the lamps will be damaged.

3, completes the corresponding protective measures, but different types of products may have different requirements, so be sure to read the instructions carefully, contact professionals to operate during construction, if found bare wires, handle them immediately, which can reduce the probability of safety accidents.

Let me sum up: the above is the connection method of LED lamp power cord. From the above article, we can see that we must be careful when using LED lights, so as to avoid subsequent failures and save more manpower and material resources. I hope it will help everyone.