Materials and steps of hand-made camera

1. Draw a circle on the paper box according to the size of the paper tube.

2. Cut off the drawn circle so that the paper roll can be inserted into the hole.

3. Paint the back of the carton, re-paste it and restore it to the state of a small box.

4. Mount the paper tube, stick the bags on both sides and fix them, and stick a button on the top left of the camera as the shutter.

5. Finally, draw a flash on the upper right with a silver or white pen.

Extended data

Precautions for camera protection

1. Don't expose the camera to drastic temperature changes.

For example, after taking photos in the snow, immediately enter a warm place indoors. The parts of the camera will be damaged by cold shrinkage and thermal expansion caused by rapid temperature change. If necessary, put the camera in a dense bag before entering a warm environment and wait for a while before taking it out.

2. Avoid camera overheating

Overheating of the camera may lead to the failure of electronic parts, and the plastic part of the camera will also be dissolved by heating. So don't put the camera in a sealed trunk and let the sun shine!

3, with a camera belt

The little thing looks unremarkable, but if you don't pay attention to the equipment of tens of thousands of yuan, you will say goodbye as soon as you land.

4. Install the battery handle and quick release board of the camera.

The principle is similar to the protective case of a mobile phone. If the battery handle or quick release plate is damaged or scratched, it will be less painful and easier to replace and maintain.