Traditional Culture Encyclopedia - Photography and portraiture - Ma 6' s reversing camera is broken. Is it easy to replace it?

Ma 6' s reversing camera is broken. Is it easy to replace it?

Ma 6' s reversing camera is broken, and the replacement steps are also broken.

1. To change the camera, you must first remove the decorative panel of the trunk.

2. This decorative board should be removed from the inside. First, remove the partition on the trunk lid. It is very simple. Just remove the black bean screw.

After disassembling, you see the exposed trunk. Find the buckle of the trunk outer panel, a white plastic rivet on the left, and just squeeze it to the outside.

4. The right side of the buckle is next to the mounting hole of the reversing camera, which is also buckled. Squeeze it and push it out.

5. Just unscrew the nut, which is the fixing screw of the trunk outer plate.

6. Don't miss it. There is a pair of such screws on the left side of the right door lock module. Unscrew the nut in the same way. By the way, unscrew the trunk lock, so that the trunk decorative plate will be completely separated, and you can take out the original camera, install a new one and clip it in.

7. The next step is wiring. Be careful. There is no order. Connect the yellow video cable or the red power cable first.

8. Plug in the red power cord, which is also docking, and then connect the positive electrode with the tail lamp positive electrode, so that the negative electrode can be left alone.

9. When the wiring is finished, pay attention to wrap some 3M tape to prevent water, electricity and wolves.