What is the color problem of SD Gundam's model of the Three Kingdoms? I'm a novice in this field. /I am a novice. /I am a freshman.

The color separation of the models of the Three Kingdoms series is relatively poor, so the difficulty of coloring is the biggest among Gundam models. Therefore, it is not recommended for beginners to draw from the Three Kingdoms, but if you really love it, I will teach you some coloring skills. It is not impossible to draw with a marker, but because painting with a marker will leave pen marks, which will greatly affect the appearance, it is recommended to draw with a spray pen, but the cost is too high. I suggest you go to the model shop to find someone to help you guide. Using a spray pen means that you need to spray paint. The common and professional brands of model paints on the market are Tamiya, Genji and Gaia. These can be paints you use for models, which can be divided into oily and water-based, but the spraying effect is similar. Please choose according to your personal preference. In addition, when using paint, you must use thinner, dilute the paint to the concentration of water before spraying. Gou Xianbi can be used to cross the line, that is, the line is infiltrated, but the line drawn by this method is very thick, and it depends on personal skills, otherwise the line will be difficult to see and distorted. So generally speaking, the model is made of Tamiya X- 1 enamel mixed diluent, and the ratio is about 1: 3, and then the diluted enamel is dipped on the model surface with a face pen (that is, a very thin brush). Gently wipe the contaminated part with a cotton swab dipped in diluent, which can thoroughly clean the spilled or redundant or contaminated part (but be careful not to wipe off the lines, this process tests the degree of care and skill). PS: In some places, the lines of the model parts are not clear enough, and the infiltrated pigments are not easy to adhere to the model lines. As long as you carve the lines along the model lines with a carving knife or a utility knife, the infiltrated lines will be easy ~

PS(2): Thread infiltration should be carried out after coloring ~

PS(3): Modeling is a process of testing patience and care, please be patient ~