Woven plain needle without skew.

1. Why isn't the cotton flat needle inclined?

People in textile mills say that cotton thread is oblique because it is "strong" and has tight twist. If you weave a flat needle or an up-and-down needle, it will always tilt upward with its "strength". If you weave a flower, you will pull its "strength" and it will not tilt. Knitting flat needles or upper and lower needles, if mercerized cotton, will not be so inclined. And all-cotton thread are knitted into flat needles or upper and lower needles. If you don't want it to tilt badly, you can add a layer of wool or acrylic cashmere on it.

2. How to knit a sweater with cotton yarn without skewing?

cannot

Denim is a kind of cotton cloth with two diagonal lines on it and a diagonal line of 45 on the left. The front twill grain is obvious, but the back mottled twill is not obvious.

There are two kinds of coarse twill and fine twill. Cotton yarn larger than 32 gauge (less than 18 inch count) is used as warp and weft of coarse twill; Cotton yarn below18 (more than 32 inches) is used as warp and weft of fine twill. Twill fabrics are white, bleached and variegated, and are often used as the lining of uniforms, sportswear and sports shoes, and also as the backing and pad of emery cloth.

3. Why does cotton thread twist clothes?

Woven linen will not skew.

The flax thread is skewed because the cotton thread is "strong", which is the reason for tight twisting. If you weave a flat needle or an up-and-down needle, it will always tilt upward with its "strength". If you weave a flower, you will pull its "strength" and it will not tilt. Knitting flat needles or upper and lower needles, if mercerized cotton, will not be so inclined. And all-cotton thread are knitted into flat needles or upper and lower needles. If you don't want it to tilt badly, you can add a layer of wool or acrylic cashmere on it.

4. Why don't cotton flat needles slash?

1. Flat stitch: It is an embroidery method that uses gold and silver thread instead of silk thread. The method: firstly, lay gold thread or silver thread on the embroidery ground, and then needle it with short silk thread. Every needle gauge is one and a half minutes, and it is circuitously filled according to the embroidery pattern, including two or three rows and several rows. Tie the thread on the flower like a cross pattern, just like the sole pattern.

The disorderly needle embroidery is a brand-new development of Chinese embroidery in modern times, and it is also a conceptual breakthrough and technical breakthrough produced by the founder under the brand-new cultural resources and thinking state. Random stitch embroidery mainly uses long and short crosshairs and layered coloring to express the picture. Lively needling, smooth lines, rich colors, strong layering and unique style. Good at oil painting, photography, sketch and other embroidery works.

5. How to deal with the skew of flat knitting machine?

1, when it is woven into a piece, let's talk about the latter piece. The front and back films are basically the same First, sew 5 stitches on both sides of this piece, and then cycle 2 stitches, that is, one stitch on each side.

2, for the sake of beauty, you can knit like this: in the first row, knit 2 stitches, pick the third stitch, knit the fourth stitch, and then dial the third stitch to the fourth stitch, thus receiving a stitch. When knitting to the third and fourth stitches from the bottom of the first row, two stitches are combined with one flat stitch, and then two flat stitches. When I come back, I don't accept needles. The third line is the same as the first line. Although they all take one needle, the previous method is different from the last method, and it will be effective to take more needles.

3. Keep both sides until the width of the collar remains. A sweater has 100 stitches, 40 stitches in the middle, 5 stitches on each side first, and then 25 stitches on each side.

4. The front piece of the needle is the same as the back piece. When it is woven 2 inches away from the back piece, the collar is closed. Don't forget to close both needles at the same time. Finally, there are only 1-2 stitches left on the collar and sleeve side of the front piece.

The needle receiving part of the sleeve is exactly the same as the front and back pieces, but the number of needles left on it is different. If there are 20 stitches left on the sleeve, add 60 stitches, that is to say, when the sleeve is knitted from bottom to top, slowly add it to the widest part of the armpit, at least 80 stitches should be added. Finally, sew.

6. Jump the shoulder needle and hit it back and forth. The number of stitches is gradually increased until it is wound into a complete sleeve, and then the number of stitches is gradually reduced according to the length of the arm until it is completed.

6. Why isn't the cotton flat needle inclined?

When knitting, the fingers of the right hand keep winding the thread on the needle, and the knitted thread is in a semi-rotating state.

It rotates in the same direction as the thread joint, so it will get tighter and tighter.

Tip 1: Fix the thread on the ball with a pin at the right time, and then pick up the thread, and the ball will rotate loosely.

Tip 2: Wool is mostly two or more strands of twine.

1) The yarn that has just started spinning is single-stranded and has poor fastness.

2) In order to increase fastness and beauty, it is necessary to combine two or more yarns into two or more strands.

7. How to weave an unbiased flat needle?

If knitting with body needles, the V-neck is inclined in a V-shape, and 3 needles are selected every four rows. At the corner, the needle position is lowered, or more needles need to be selected; Pick from the left shoulder or right shoulder, because it is not easy to find the starting point; Pick the needle is to pick it on the surface, and the edge will naturally be involved when picking it; When knitting a V-neck, you should first look at whether you are knitting a low needle or a high needle. In short, the center of the V-neck must be knitted with a low needle.

Knitting method of sweater collar II

Let's take a look at the knitting method of the collar of the round neck sweater. Leave about 20 stitches at the front collar of the round neck sweater, which can be woven to about 5-6 cm. Dig the back collar, too The back piece can be left a little more according to the personal size, not as much as the front piece, so it is easy to get a small and round collar.

Knitting method of sweater collar 3

If you want to leave 20 stitches at the back neckline, you only leave 16 stitches at a time. The other four stitches, when knitting shoulder stitches, are cut out at the same time, which is a little radian. shoulder

8. Why is the plain weave uneven?

6. 5 to 7 inches from armpit to shoulder.

Knitted sweaters with high count fabrics are generally tight, so low count fabrics are easier to pilling than high count fabrics.

Fabric with flat surface is not easy to pilling, while fabric with uneven surface is easy to pilling. Therefore, the pilling resistance of fatty flower fabrics, common color fabrics, rib fabrics and plain knitted fabrics is gradually enhanced.

Dyeing and finishing process: After dyeing and finishing, the pilling resistance of yarn or fabric will have a great influence, which is related to dyes, auxiliaries and dyeing and finishing process conditions. Yarn dyed with hank yarn is easier to pilling than yarn dyed with loose wool or tops.