Do you know how the level is made? Can you share the production steps?

The level meter is a leveling tool based on the principle of liquid level, which is accurate in cost ratio and convenient to carry. It is the most common measuring instrument in the construction process. So how is the level made?

First, the production level should only start with the suppression of battens. First, dig five holes in it with a slotting machine, three of which are filled with bubbles in the spirit level, and the other two are used as sleepers. After drilling the hole, remove the burr on the edge of the wood, cut a groove on the edge and pour gay champagne into it. Then, the copper strip used for edging is pulled to the forming machine. First, the bent copper strip is flattened and straightened by a roller, and then the copper strip is folded into a specified shape so that it can cling to the groove of the bar. Then put the copper edges on this machine, and the machine inserts them into the groove to reinforce the edge of the whole wood strip.

Second, in another workshop of the factory, workers are making standard bubbles. First, they use machines to melt plastic and shape bottles. There is a little bend inside each vial, so that the bubbles have a place to stay. Then Xiaoping will send Xiaoping to the gripper through a vibrating feeder. The clamp rotates each pin so that its opening faces upwards. Then the machine injects yellow mineral oil essence into it, leaving only the space needed to form bubbles. Then the mechanical arm covers Xiaoping with a plastic cover, and at the same time, the plastic wool is connected to the vial with an ultrasonic welding machine to complete the sealing. Next, Xiaoping will be sent to the inspection station, where a small camera will shoot the bubbles and check them by computer to ensure that the bubbles must be 1.2 cm wide.

Third, if they pass the inspection, these Xiaoping will hot stamp the central slogan on the small bottle through the printing machine. This is a standard bubble, but it needs to be baked for 24 hours. The heated standard bubbles will highlight defects, and the defective standard bubbles will be screened out. Then the worker used red lanterns, so that it was illuminated when she slowly opened the drum. Now use a computer scan to check the displacement of the bubbles inside. If the displacement is too large, the accuracy of the level will be affected. The level bubbles that pass the test will be put into the welding machine. He will form a base of horizontal bubbles in the sacred gap of molten plastic, and then coat the base with super glue to stick the horizontal bubbles to the opening of the wood strip. Two horizontal bubbles are installed in each tank, and the number of each bubble must be completely horizontal. Workers will confirm whether it is horizontal according to the enlarged image on the monitor. Some level bubbles need to be installed vertically to measure whether the wall is vertical. Then, glue is coated on the outside of the level bubble, and an acrylic frame and a small window are installed to protect the level bubble. Finally, rubber caps are installed at both ends of the level gauge and printed with trademarks. These made levels can be used to measure the horizontal state of objects.