What is the brief introduction of the use and installation process of machine tool working lamp?

Machine tool working lamp is a special machine tool, which is widely used to process magnetic materials and parts with special shapes, and plays an important role in machinery, mold, light industry, motor and other industries. The General Administration of Quality Supervision, Inspection and Quarantine (AQSIQ) recently conducted a supervision and spot check on the product quality of electric machining machine tools, and found that both the product itself and the instruction manual have very prominent safety hazards.

Machine tool working lamp grinder should not be placed outdoors for a long time when it is transported to the factory. The local sunlight will affect the accuracy. When lifting and unloading this machine, the copper cable exceeding 10mm should be used to lift it through the hook, or the stacker should be used to unload it, but attention should be paid to the position of the center of gravity to avoid toppling. When receiving the goods, we should check whether the details and specifications of the goods are consistent with the delivery order. If there is any discrepancy or shortage, please indicate it on the delivery note for handling. The parts of the machine coated with antirust oil are wiped with a soft cloth dipped in kerosene. Installation location: generally, the cement thickness is above 150mm, so as to avoid vibration and direct sunlight. If installed near a moving bed, planer, etc. There must be an earthquake-resistant foundation project. Install it in the order of base, horizontal adjustment screw and this machine.

All electrical components of the machine tool are essential, otherwise emergency measures cannot be taken in case of accident, such as machine tool working lamp, which can play an emergency stop role in case of machine tool accident and effectively protect the operator. Generally, WEDM has two operating positions. According to the standard requirements, an emergency stop button should be set at each operating position, but many enterprises only set an emergency stop device at one operating position. Mechanical and electrical double limit should be set for its travel, but most enterprises only use single limit, and some enterprises even have no safety limit at all; In the spot check, some enterprises choose inferior components, for example, some enterprises choose low-priced inferior working lights, which will break the lamp cap soon after use, leading to short circuit and fire; For another example, some enterprises choose cheap control transformers, which have large calorific value, exposed terminals and no safety protection measures, leaving potential safety hazards for products. In addition, the five products sampled this time are not equipped with power-off switches.