How big is the secondary air inlet of the wood gas stove?

The secondary air inlet of the wooden gas stove should be 635×350mm, and the maintenance of the gas stove:

1、? Please use a soft rag dipped in a neutral and non-corrosive cleaner to clean the pot rack;

2、? Please clean the kitchen surface with a soft rag or sponge dipped in a neutral and non-corrosive cleaner; Avoid using chlorine-containing cleaners on glass cooktops. When cleaning, please don't let water enter the shell through the liquid tray or knob hole plug;

3. If the flame is uneven or individual fire holes are flameless during the use of the gas stove, please turn off the gas stove. After the burner is cooled, go to the fire cover in time, clean the dirt and carbon deposit in the fire hole with a thin steel needle, and then use the gas stove after treatment. Do not directly impact the fire cover with water (because bubbles will temporarily block the fire hole), and do not wipe the dirt on the surface and seat of the fire cover with hard objects;

4、? After cleaning, please refer to the burner component drawing to correctly install the fire cover seat, inner and outer ring fire cover and pot rack, and ensure that they are installed in place, otherwise the uneven flame and flame isolation will affect the normal use of the gas stove.

Matters needing attention for energy-gathering firewood stove:

1, the charge should not be too full, and the upper plane of the fuel must be more than 3 cm away from the muzzle. Users are advised to control that one charge is just used up;

2. In order to ignite easily, put some flammable kindling materials (combustible substances such as wood shavings, dry leaves or thin strips) on the fuel;

3. After cooking, you must use up the remaining fuel in the bucket or take it out and turn off the fan. Pay special attention not to directly suffocate on the stove to make a fire;

4. After the fuel is used up, you can take out the cylinder with the installation hook and dump the burnt ashes, paying attention to safety and fire prevention;

5. When the firepower is adjusted, the amount of adjustment should not be too large at a time, and the firepower will change about 20 seconds after adjustment;

6. Don't touch the surface near the water tank and intersection before the stove is cooled after use, so as to avoid burns;

7. The smoke exhaust pipe must be connected to the outside, and there must be no inflammable and explosive articles around the smoke exhaust pipe and near the exit.

Baidu encyclopedia-chaihuozao