Traditional Culture Encyclopedia - Tourist attractions - Hand-woven red rope tutorial

Hand-woven red rope tutorial

The tutorial for hand-woven red rope is as follows:

Preparation materials: an 80cm rope (axis), a two-meter rope (braided wire), two clips, a Scissors and a lighter.

Fold the 80 cm rope in half, leaving 12 cm at the fold, and clamp it with a clip. Just clamp the other end directly. Then fold the two-meter rope in half to find the center point, and place the center point under the axis. Then pull the thread on the left to the right. Then pass the thread on the right through the hole on the left from under the thread on the left and thread it up.

As shown in the picture below, then tighten the thread and push it to the clip. Use the right thread to pull to the left. Reinsert the left thread. Hold the thread on the right and pass it under the axis and through the circle on the right. Then pull the thread tightly and push it to the clip.

Please click to enter the picture description

Then continue to repeat, step 1, 2, and continue to edit like this.

Please click to enter the picture description

This is the effect picture that has been compiled for a paragraph.

Please click to enter the image description

After editing it to the required length. Cut off the ends of the braided wire and burn it with a lighter.

Please click to enter the picture description

Overlap the thread ends on both sides of the axis, tie it with a double flat knot to the required length, cut off the thread ends and burn them with a lighter, as shown in the picture below .

Please click to enter the picture description

Tie two thread ends on each side of the axis and tie them together into a knot. As shown in the picture below.

Please click to enter the picture description

The following is the braided bracelet.

Please click to enter the picture description